answersLogoWhite

0

What else can I help you with?

Related Questions

What are four sentences for the word pinch?

Do not pinch your sister.Please don't pinch my bike.I added a pinch of salt to the recipe.Ouch, don't pinch my arm!


Is it bad if you pinch somebody that is wearing green?

I would not pinch anyone regardless of what color they are wearing.


How do you paralyze someone's arms?

pinch the radial nerve causing a temporarly paralyzed arm.


Do you get bad luck for 7 years if you pinch someone who is wearing green on St. Patrick's Day?

No, if you break a mirror you will have 7 years of bad luck. If you pinch a girl, you will get your face slapped. If you pinch a guy, you will get your nose broken.


If you are pinched can you contract shingles?

i depends on where you are pinched, maybe not if you pinch your nose, but if you pinch your behind or your arm near a roof you may get shingles. If you need shingles and you let a roofer pinch you, you may get shingles for free! good luck


Where do you put a tire jack on a 2007 Chevy Cobalt?

Under control arm or pinch weld


How many calories are in a pinch of sugar?

In one pinch of sugar there are about 3 calories! But dont ever forget that cookie sugar is bad!


how much should I feed my doghow bad is it to get a broken arm?

i is unsure and its really bad to get a broken arm


Iv have had a dead arm for 3 days What is wrong?

Bad or blocked blood circulation - you should get medical help immediately


How do you remove wiper mecedes C230?

it's in the manual. just pinch the clip down on the arm and slide it right out


How to replace control arm - ball joint 1986-1995 Taurus Sable?

According to the Chiltons Repair Manual, on 1986-1995 Taurus / Sables, the lower ball joint is an integral part of the lower control arm and is not replaceable - replace the lower control arm as an assembly.Replacing the lower control arm isn't all that bad of a project...Prep: Raise and support front end - remove wheel, caliper, rotor* Remove 'tension strut' nut - that's the bar coming from the frame out to the middle of the lower control arm * Remove the 'pinch bolt' at the bottom of the steering knuckle holding the lower control arm / ball joint stem - it would help to open up the pinch with a small pry bar * Remove bolts from inside control arm frame mounting / pivot point Install:* Place control arm over the end of the tension strut* Reattach control arm to frame pivot point - torque nut to 73-97 ft. lbs. * Align the 'grove' in the ball joint stud with the pinch bolt opening -* Line the stud up with the angle of the steering knuckle opening and insert * Insert pinch bolt and torque to 40-53 ft. lbs. * Time to put the nut and dished washer on the tension strut - dished washer facing AWAY from control arm (frontwards) - torque to 73-97 ft. lbs. Re-install caliper, rotor and don't forget the front wheel.


How do you do the spider pinch?

To do the spider pinch you must grab a lump around the back of your sholder close to the neck and pinch it. This will cut the blood flow to your arm adding a tremeds amount of pain witch will make your apponent fall to the ground. WARNING do not hold the spider pinch for longer than 30 seconds or it may cause a deathly blood clot to the sholder.