ad is multiplex address data line bus
The 8085 microprocessor's AD bus goes into high impedance state before switching as a data input bus because you don't want two bus drivers driving the bus at the same time. You give the bus time to float between transfer of control, otherwise there will be large power transients at switchover, and you could damage the drivers.
The address bus is a section of the bus that emits the address of the desired instruction or operand.
the bus through which the data are transmitted or received within microprocessor and with peripherals is called as data bus.when used internally to microprocessor called internal data bus.
since data can be read /write from/to the microprocessor, hence data bus is bidirectional. if data is required read from microprocessor then it will be pointing to a memory location by the address bus, by indicating which location data its required to read. similarly to write a data to a location, again the microprocessor will be to that particular location by holding that address in address bus. hence it will be unidirectional.
Bus cycle is a single transaction between the main memory and the CPU.
RIMM
group of wires or lines that are used to transfer adress between microprocesssor and i/o devices one way and of 20 bits while data bus uses bothway transfer of data between microprocessor and i/o devices of 16 bits
for demultiplexing address/data bus
Data bus
It provides timing signals.
The data bus.
32 bit