There would be a steel resistance wire or some sort of ballast resistor to limit incoming voltage from the key to the hot side of the coil. That would need to be eliminated when switching to HEI. Also, HEI requires minimum 8MM spark plug wires. Then just switch distributors or install the HEI module in the original distributor, and you're good to go.
Need to know what year the vehicle is and is it still a points car or is it electronic ignition.
No summit will sale you a kit
well you first need to tell someone is it electronic ignition or dose it have points ??
Hate to answer a Q with a Q but WHOSE timing? Valve, cam, ignition? Need to be more specific. If I ASSUME ignition timing then it still requires more info as the type e.g. breaker points or electronic? Clarify the Q and answers can be rendered.
You can use the same flywheel but need to put in a complete solid state ignition set up. http://store.chainsawr.com/
If you havent already got one you will need to put an electronic ignition box on the truck. They're pretty easy to install.
The ignition switch should be separate from the ignition key/lock assembly, so I'll say no.
Constant voltage delivery Eliminate the need for periodic replacement of points and condensor
There would be a steel resistance wire or some sort of ballast resistor to limit incoming voltage from the key to the hot side of the coil. That would need to be eliminated when switching to HEI. Also, HEI requires minimum 8MM spark plug wires. Then just switch distributors or install the HEI module in the original distributor, and you're good to go.
i need the bracket that the ignition cylinder slides into.... the piece that mounts to the stering column
Go to Regedit: HKEY_LOCAL_MACHINE\SOFTWARE\Electronic Arts\Electronic Arts\Need for Speed Shift\ergc
The electronic engine unit is located underneath the passenger glove compartment,you will need to remove the underside cover(3 screws and one nut)