A source of heat.
1200 foot propane furnace what size do i need
It takes about 5 to 10 men to work a steamboat furnace
form_title= Furnace Parts form_header= Keep warm with a working furnace. How old is your furnace?*= _ [50] What parts do you need?*= _ [50] Please explain your issue in detail.*= _ [50]
Cost depends on where the furnace is to be relocated. Duct work transitions may need to be made, electrical and gas lines may also need to be ran. Contact a reputable HVAC contractor to give you an estimate.
form_title= Outdoor Wood Furnace form_header= Stay warm with an outdoor wood furnace. What is your budget for a furnace?*= _ [50] What size furnace do you need?*= _ [50] Where will the furnace be installed?*= _ [50]
no because you need a fork an a knife to eat your cat
That will depend entirely upon the type of furnace you have. There are filter less furnaces, so if you have one, you won't need filters. Otherwise, if your furnace requires a filter, you will need to purchase filters and replace them regularly. If you have the owners manual, that will tell you if the furnace needs a filter.
When the furnace in your home goes out, there are a few things that you need to look at before you get a new furnace. Get the furnace serviced by a professional electrician who will check the heating coils as well as the filter in the furnace. Check the circuit breakers in the furnace to ensure that they are working properly. If the breaker is not making contact, this could be all that you need to replace.
yes u can if u are good with duct work put a down draft furnace in a basement and pipe it up one floor well not recommended it will work i did this to help a lady get threw winter who had low funds and it has worked quite well u need to build a custom box for the furnace to sit on to make this work and pipe directly from box and use smallest duct work u can i.e mobile home duct work or 4 to 6 inch What you did is still a downdraft furnace
The size of the furnace depends on the square footage of the house you are heating.
no you need power to run the board and the igniter
Yes, I do.