answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: What do you use to repair a hole in an upper plate?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you repair a broken delft plate?

Use glue that use made for pottery and follow the instructions on the glue.


Repair Pinhole water line icemaker?

Cut out the section with the pin hole and use a compression union


Can you use stop leak to seal a pin hole in radiator on a 1998 grand prix?

For a temporary repair, yes and use as directed.


Where is the fill hole on a 1999 Manual transmission dodge ram?

Normally the hole to check the level and add gear oil is on the upper side of the transmission. You use the same hole for both. Can be on the driver's or passenger side.


What do you use to get to the top of the clock tower on wild west island?

You go in to the hole in the tower and make your way to the upper right.


How do you get out of jailcell in The Legend of Zelda Twilight Princess?

Go to the upper right corner and use dig around there and there should be a hole.


What can be done to repair the hole in the ozone layer?

In order to repair the ozone layer, we must decrease the use of ozone depleting substances. These are the ones containing CFC's which deplete the ozone layer.


How do you repair drywall hole and vapour barrier?

I tape the broken vapour barrier with red 'Tuck' tape then put a wood backing in the hole and use small pieces of drywall to patch.


Can you get your car towed to a garage mechanic if it is not registered?

Yes. The garage can use their repair plate on the unregistered vehicle to make it legal to tow.


How do I repair a towel rack without a molly bolt when the hole is located over a joist?

Use a longer screw and go into the joist.


How can the ozone hole above Antarctica repair?

Yes, it can be repaired. It is possible if we curb the use of ODS i.e. ozone depleting substances.


How do you remove butt stockof 12 GA diamond arms shotgun?

Remove the butt plate. There will be a hole. There should be a slotted screw at the bottom of the hole. Use a long screwdriver and be careful to not damage the stock.