Want this question answered?
Yes, if the device calls for it. My touch lamp at home specifically calls for a "type B" bulb... problem is... I can't find a bulb for it!
Not wanting to state the obvious but the wall switch has to be turned on to supply voltage to the outlet. The lamp will need a three way light bulb in the lamp. A three way bulb uses two filaments of different lengths. One element is used for low brightness, the other filament for medium brightness and the high brightness setting uses both filaments in the bulb. If a single filament ordinary light bulb is used in place of a three way light bulb there will be a position on the three way lamp switch where the bulb will not light. Find the position on the lamp where the bulb will light and leave it there. Use the wall switch to turn the lamp off and on through the controlled receptacle.
using an ordinary bulb shouldn't effct it the holder that the bulb could be broken or corroded
No...
A subsystem for a lamp would be the bulb because the bulb lets the eye see.
Yes, if the device calls for it. My touch lamp at home specifically calls for a "type B" bulb... problem is... I can't find a bulb for it!
Not wanting to state the obvious but the wall switch has to be turned on to supply voltage to the outlet. The lamp will need a three way light bulb in the lamp. A three way bulb uses two filaments of different lengths. One element is used for low brightness, the other filament for medium brightness and the high brightness setting uses both filaments in the bulb. If a single filament ordinary light bulb is used in place of a three way light bulb there will be a position on the three way lamp switch where the bulb will not light. Find the position on the lamp where the bulb will light and leave it there. Use the wall switch to turn the lamp off and on through the controlled receptacle.
using an ordinary bulb shouldn't effct it the holder that the bulb could be broken or corroded
It is a safety concern. With the switch before the bulb, the bulb is completely isolated from the potential source when the switch is turned off. With the switch behind the bulb, even if the switch is turned off, the potential source is still at the bulb. If any of these lamp holder parts touch the ground when removing the bulb the circuit will short out and trip the breaker. If you are grounded and touch any of the lamp holder parts you will get a nasty shock.
Assuming this is for one of the 2 rear fog lamps, then remove the three bolts from the rear lamp housing. The fog lamp is the bottom bulb in the set. Give the bulb holder a quarter turn anti-clockwise and remove the bulb and holder from the lamp housing. The bulb is held in place by a plastic clip either side. Spread the clip sideways slightly and the bulb will pull out. Put new bulb in and replace.
Lamp have required high rating to glow & have a specific luminus area.exa-table lamp,florucent lamp,sodium vapur lamp,BUT but bulb have no required rating exa- halogin bulb
Find the wattage rating on the dimmer controller. This is the maximum allowable wattage that the lamp in the fixture should be. Lamp wattage ratings under the rated dimmer wattage is fine but do not install a larger wattage lamp that is over the dimmer control's rating.
In the home, LEDs have the highest efficiency, using 10-15% of the power of an incandesecent bulb of the same brightness. A CFL bulb uses 20-25% of the power of an incandescent, while a halogen uses about 70%.
No...
== # Remove screws attaching license plate lamp to rear bumper # Remove lamp from bumper. # Remove bulb socket from lamp. # Pull bulb from socket. == # Install bulb into socket. # Install bulb socket into lamp. # Place lamp in position. # Install screws attaching license plate lamp to rear bumper.
A subsystem for a lamp would be the bulb because the bulb lets the eye see.
A subsystem for a lamp would be the bulb because the bulb lets the eye see.