Its simply multiplication of voltage applied and current.
in welding machine, the transformer used is basically a current transforrmer. so by changing the tap of secondary side of transformer, we can increase or decrease the current in the transformer.
why does have to short-circuit secondary wire of current transformer ?
The difference between current transformer and potential transformer is that the secondary of a current transformer can not be open circuited while under service whereas that of the potential transformer an be open circuited without any damage to the transformer.
It is a transformer with No load attach to it.
A: As current flow in the primary it will magnetize the core of the iron in the transformer that is called magnetizing.
Its simply multiplication of voltage applied and current.
If by 'loss current' (?) you mean the 'copper losses', then there is no practical way of doing so without reducing the load current. Perhaps you should explain what you understand 'loss current', in the context of a step-down transformer, to mean?
if you mean T-3t+2t+4 (T and t is different variables):T-3t+2t+4=T-t+4if you mean t-3t+2t+4:t-3t+2t+4=4
in welding machine, the transformer used is basically a current transforrmer. so by changing the tap of secondary side of transformer, we can increase or decrease the current in the transformer.
why does have to short-circuit secondary wire of current transformer ?
The difference between current transformer and potential transformer is that the secondary of a current transformer can not be open circuited while under service whereas that of the potential transformer an be open circuited without any damage to the transformer.
It is a transformer with No load attach to it.
A current transformer is primarily used at the neutral point of a transformer for earth fault protection. A neutral current transformer will measure any ground fault current which will essentially flow from the star point of the transformer. A fault-detection device other devices is connected to the current transformer and, if the fault current exceeds a certain trigger value, the fault-detection device will give a trip command to an earth-fault relay to disconnect the supply of electricity to the transformer.
A transformer can only increase or decrease the voltage of an alternating current, and it is called step-up transformer or step-down transformer accordingly.
Yes, a transformer has eddy currents.
It basically means like lets say you have 2t-5=-1 the T would equal 2 if you solve it right. unless your doing a different question invovling variable 2t