0
What else can I help you with?
What means engine code P0157 for Isuzu Rodeo 1998?
You have a bad o2 sensor (low voltage)
Where are the oxygen sensors on 1997 Isuzu Rodeo?
it depends on the model of engine, my 97 rodeo with the 4ze1 motor has the map sensor for air intake but doesnt have an O2 sensor for the exhaust.
Where is the o2 sensor located on a 1997 Isuzu rodeo?
the o2 sensors are located on the exhaust pipe one by trans and one by the muffler there is 2 of them
Where is the o2 sensor on a 1995 Isuzu Rodeo?
its on the end of the wires just above the air filter housing unit
Where is the bank 2 o2 sensor on a 2004 izusu rodeo?
the bank 2 is on the driver side i got this info from an Isuzu mechanic
How do you replace o2 sensor on Isuzu i290 2007?
Right next to the oil filter
What does code P1171 on an Isuzu Rodeo mean?
i have just gone through this same situation, in my case it follows with i think 1157 or 1137 regardless they are o2 sensor codes. funny enough this , in my case, led to the MAP sensor found center rear of intake manifold. worked for me 100 CAD new pop it out and replace it should be good as new! Good luck
Where is the O2 sensor in bank 2 located in your 1996 Isuzu trooper?
Bank 1 is the side that cylinder 1 is on, sensor 1 is downstream and sensor 2 is upstream
Where and how do you change the oxygen sensor on a 2000 Isuzu rodeo And is there a site that you can find a detailed diagram?
Truck has 4 sensors 2 pre 2 post catalytic. Which one do you need 7/8 wrench or o2 sensor socket to replace What fault code is set/ I can tell you which one you need if you tell me the code
How many O2 sensors are on a 1996 Isuzu Rodeo?
Mine has 4 O2 sensors, one before, and one after the CAT on each bank. (just a FYI, I was getting an O2 lean error caused by the short flex pipe just after the Y leaking)
Where is the O2 sensor on an Isuzu axiom?
On an Isuzu Axiom, the O2 sensor is typically located in the exhaust system. There are usually two O2 sensors: one positioned before the catalytic converter (upstream) and another after the catalytic converter (downstream). To access them, you may need to lift the vehicle and inspect the exhaust piping. Always refer to the vehicle's service manual for specific details and locations.
Where is the bank one o2 sensor on an Isuzu Rodeo and how do you change it?
I'm not a mechanic, but I'm pretty sure you have one O2 sensor just before the catalytic converter and one after. The first checks the function of, and regulates, your fuel control unit, and the second checks the efficiency of your catalytic converter. My #1 O2 sensor is screwed into the exhaust pipe about a foot or two before the converter and kind of looks like a spark plug. On a 2003 Isuzu the O2 sensor is on the driver side of the engine compartment about a foot down from where the exhaust pipe comes out of the header. Just follow the exhaust pipe out of the engine and you will see it. It looks like a spark plug sticking out. It's pretty easy to disconnect the wires, unscrew it and replace it. You will need a 7/8" open end wrench to unscrew it. Good luck. * 1999 Oldsmobile Aurora's actually have 4 O2 sensors, 1 on each header and 1 before, and 1 after the catalytic converter...
