Want this question answered?
Fuel Fail 47 Idle speed contol valve - coil 2: Open or short circuit.
The Haynes manual says an error code 69 is a neutral safety switch circuit / Engine cranks in drive (adjust or replace switch). Note: the Shift cable for the Automatic Transmission stretches over time and should be adjust, if too long cable will need to be replaced.
It is the code for the TPS Throttle position sensor
In 1990-1994 XJ6 the VCM Code 44 is the code for the O2 sensor, either rich or lean exhaust has been detected and is causing the code to trigger. It could indicate a bad O2 sensor.
what means fail 44 of vcm of jaguar
Idle speed control valve coil 1 fault. Off voltage not less than 0.85 volts or on voltage not exceeding 12.25 volts.
The throttle potentiometer is not functioning properly. Unlike most parts this one is easy to get to, but unless you're a mechanic or know how to use a volt meter I would take it in for this problem.
This means Idle speed control motor (ISC) or valve
jaguar sovereign engine failsafe mode reset
Evaporative canister purge control valve circuit fault
what does fail safe engine mode mean on a 2000 jaguar s type? how to fix this problem?handle
low battery. had battery tested load type. faild replaced battery fix code 29 thank you