Cars & Vehicles
Plymouth Voyager

What does a code 411 mean on a 1991 Plymouth Voyager?

858687

Top Answer
User Avatar
Wiki User
Answered
2004-08-24 10:22:46
2004-08-24 10:22:46

You should only have a 2-digit code. Here is a link to the entire list: A "41" indicates "charging system excess or no field circuit." Good luck.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


No vacuum change at the MAP sensor.

Trouble code P1698 means: No CCD Messages Received From The TCM

Trouble code P1698 means: No CCD Messages Received From The TCM

Trouble code P1698 means: No CCD Messages Received From The TCM

Trouble code p1784 means: Pressure switch circuit: LR

Means fuel injector isn't coming on, just got it myself

Loss of Camshaft or Crankshaft sensor read at the PCM.

I assume you have an electronic controled transmission. OBD II Code: P0755-----Shift Solenoid "B" Malfunction. Jim

P0300 = random misfire. Could be as simple as needing a tune up.

I believe that a 54 code is for Turbo only. It may be the synchronization pick up circut. It is not showing a distributor synchronization signal.

MIL Code 11 = No crank reference signal detected during engine cranking. Good luck!

Per code manual P0700 is Trans control system malfunction. You need to have the transmission computer checked for codes.

CODE 23** Indicates that the air temp sensor input is below the minimum acceptable voltage or sensor input is above the acceptable voltage.

22- Coolant sensor signal out of range22- Coolant sensor signal out of range

No such animal that i am aware of. Plymouth Voyager minivans could not have a manual transmission in the USA after 1995. The 2.0L engine was never offered in the Voyager here. If you mean a Plymouth Neon or Breeze, the Centerforce part number is DF325417, and that fits the 2.0L engines only and includes a new flywheel.

o2s signal stays below center (lean) oxygen sensor signal input indicates lean air/fuel ratio condition during engine operation

The code numbers are two didgit codes. That was probably a 12 and a 55. 12 is start of message, 55 is end of message. Basically that means there are no trouble codes.

There are several possibilities. You could have a caliper that is sticking or you have a warped rotor.

P0340 Camshaft Position Sensor Circuit Malfunction

Code 37 is for a malfunction in the torque converter clutch circuit.

That is a code that the engine computer sets when the trans computer has also set a code, you need to have the transmission computer checked.

Code 55 is end of message ( it is done flashing codes )Code 12 is start of message or battery was disconnected.Code 55 is end of message ( it is done flashing codes )Code 12 is start of message or battery was disconnected.

Code 43 refers to the coil. Code 55 is end of message.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.