Want this question answered?
If the check engine line is flashing then that means there is a real problem and you should have it looked at, But if the light is on and NOT flashing the it is most likely a problem with the emmisions system and most likely an oxygen sensor.
You have to atleast be on the white line you have crossed it. :)
A flashing line in eye is one of the phenomena called a scintillating scotoma (plural scotomata).
just like was said,coolant low or bad switch,or needs air bled from the line
You would wire the switch to the first light. Code says to break the black or power side of the circuit. Connect the white to the light. Take the black down to the switch on the black wire and back to the light on the white. This is a line of wire from the light to the switch. From the first light, take the white and the return white from the switch to the second with another run of wire. This will be regular black white with ground. White to white and at the first light the return line from the switch is white but hook to the black to the second light. Second light to third just continues the two wires. Black to black, white to white. I think this is clear enough to follow. If not, ask again.
It's called a cursor.
that light indicates that you're vehicle is low on water. the big white sphere container at the top right of you're engine is the water resivoir. if the vehicle is warmed up then make sure the water level is up to the "MAX" line indicated on the resivoir tank.
Usually a big white line, if there is no line- out of the way of opposing traffic.
There are three... white, light green and light green with a black line on it.
is there something in the way if there is move it if there is sensers clear everything out of the line between both of them
it will be default or highlight because the clue word was flashing vertical lines that indicates
it is simple you go in a line from purple then stop at white.