It depends on the meter. Generally they test amperage, voltage and resistance. Some also test diodes and and various other electrical properties.
How it is done is called electrical theory and is far too large a subject to cover here.
They are called test leads, you would use them to connect the multimeter to the points that are to be tested.
Use a multimeter and test if there is a voltage drop or current over the wire circuit.
Multimeter test leads can be purchased at specialty stores like Radio Shack or some larger hardware stores. They can also be found online at Amazon and eBay.
You can check if it is shorted, but without coordinating the gate and anode voltages with the cathode, you cannot test a thyrister (SCR) with a multimeter. Check it out of circuit for shorts, then check the circuit, then test it in operation. Anything more advanced will require an oscilloscope.
A contactor is tested by using a device called a Multimeter. By setting the multimeter to ohms and rx1 you can clip both prongs to the coil. If the multinmeter moves the contactor is good. If it doesnt move its bad.
Yes it is possible to test a diode with a multimeter.
You can test a battery by using multimeter. Set the multimeter to the DC voltmeter setting and then place the leads of the multimeter across the leads of the battery. the multimeter will have a readout of the voltage.
To test an abs sensor for a Lexus ES you will need to use a multimeter. The multimeter will determine if the abs sensor works or not.
Either the supply or the multimeter is faulty.
An automotive multimeter, like any multimeter, can be used to test the voltage or current in some kind of circuit. As it is an automotive multimeter it is aimed more towards the used in a car.
Take the battery out and test it with a multimeter.
ohm the resister with a multimeter
By using a multimeter
They are called test leads, you would use them to connect the multimeter to the points that are to be tested.
You cannot test it with a diagram. You will need a multimeter to test the coil. Click the link.
A multimeter.
First connect the positive terminal of the voltage line to positive terminal of multimeter and negative to negative terminal of multimeter. Select voltage in multimeter and measure the voltage