It is still a needle, but could be referred to as a compass needle.
to use needle and cotton means to knit
Yes the Pacific Plate, North American Plate, Cocos Plate, Nazca Plate, South American Plate, African Plate, Eurasian Plate, Indian Plate, Australian Plate, and Antarctic Plate are the major tectonic plates.
it is destiny needle, and magnetic needle storm. :)
The Space Needle is located in Seattle, Washington State.
holds the needle
Common causes are: Wrong or incorrectly fitted needle, damaged or loose shuttle race, debris in race, or incorrect timing of hook. Also check position of needle through needle plate, incorrect positioning may cause needle to strike plate while sewing.
the throat plate covers the opening to the shuttle and shuttle basket. it is also a seam gauge.
"treadles" refer to the foot plate under the old-timey machine. You rock the plate up and down, to move the needle up and down....
The face plate is the vertical plate on the left side of the sewing machine. It is a protective covering for the needle bar and thread take-up mechanism. See the diagram linked below for a visual.
if it is the needle plate itself -- it is interchangeable with singer 14T948DS which can be ordered thru several sewin machie parts outlets. if it is the small removeable part with the tines on it -- you can order it from searspartsdirect.com it is terchangeable with a couple of other singer machines. part #B10311004 they are about $6 and change
NounA steel needle for engraving on a bare copper plate without acid.An engraving or print so produced.
NounA steel needle for engraving on a bare copper plate without acid.An engraving or print so produced.
NounA steel needle for engraving on a bare copper plate without acid.An engraving or print so produced.
Technically because the loop has greater surface area and you have a chance of touching more than one colony. That is very hard to do with a needle. Still, if you turn your loop on edge and dab like a needle it will do the job just as well. Also, if you have any competence at all your streak plate will have well isolated colonies in the 3rd/4th streak making this question pointless.
Technically because the loop has greater surface area and you have a chance of touching more than one colony. That is very hard to do with a needle. Still, if you turn your loop on edge and dab like a needle it will do the job just as well. Also, if you have any competence at all your streak plate will have well isolated colonies in the 3rd/4th streak making this question pointless.
First thought that comes to mind is that there is a lot of lint between the feed dogs and the needle plate. Most needle plates have screws that hold it in place, remove the plate and clean out that area. If this doesn't seem to be the problem something may be disconnected and needs professional service.