The density of steel varies based on the alloying constituents but usually
ranges between 484 and 503 lb/cu ft.
The volume described in the question is
(1.5" x 32" x 32") = 1,536 cubic inches = 8/9 cubic foot.
So, depending on the steel mix, it weighs between 430.2 and 447.1 pounds.
It depends on the length and width of the plate, and the thickness. A 12 x 12 inch piece of plate aluminum which is 1/2 inch thick has the same length and width as a 12 x 12 inch piece which is 1/4 inch thick, but the 1/2 inch piece will weigh twice as much.
The difference is a matter of thickness. For example steel PLATE is a large plate of thickness greater than 3/16 inch ( about 5 mm). Steel SHEET is plate that it LESS than 3/16 inch thick. And steel STRIP is SHEET cut into short widths. These cutoff thicknesses may very between materials depending on manufacturing processes. Hope this helps!
7.8 POUNDS
It depends on the type of steel
it depends if it is a real mirror and how thick/ tall it is :D
A half inch thick steel plate, A half inch thick plywood, Brick, Concrete Block
It depends on the length and width of the plate, and the thickness. A 12 x 12 inch piece of plate aluminum which is 1/2 inch thick has the same length and width as a 12 x 12 inch piece which is 1/4 inch thick, but the 1/2 inch piece will weigh twice as much.
1 hour
A 21 Gage Steel plate is about 1/32 inch thick. Various charts put it at .032" to .033". That is for plain steel. Galvanized, aluminum and stainless have different measurements for the same gage.
The volume of the plate is (0.5 x 20 x 45) = 450 cubic inchesThe weight is (450) x (0.28) = 126 pounds
2.27 kips
TO answer this question, you need to know the density and the volume of the piece of steel. For example, "mild steel" weighs .284 pounds per cubic inch. The volume of a 12 inch x 12 inch x 1 inch piece of steel is 12 * 12 * 1 = 144 cubic inches. .284 pounds/inch^3 * 144 inch^3 = 40.896 pounds. So each of these steel tiles will weigh about 41 pounds.
The difference is a matter of thickness. For example steel PLATE is a large plate of thickness greater than 3/16 inch ( about 5 mm). Steel SHEET is plate that it LESS than 3/16 inch thick. And steel STRIP is SHEET cut into short widths. These cutoff thicknesses may very between materials depending on manufacturing processes. Hope this helps!
It is thicker than 1/8th inch thick steel.
It is not possible to blast a hole in 2 inch steel plate with a 12 gauge slug. The slug will barely dent the plate, if it does anything at all.
Steel is typically 490 lb/cubic foot. There are 1,728 square inches in a cubic foot which means that each cubic inch weighs about .284 pounds (just a bit over a quarter of a pound per square inch).
0.0938 inch or 2.38 mm.