A choke is an inductor. The impedance of an inductor is dependent on the frequency of the current flowing through it. The greater the frequency, the higher the impedance.
Therefore an inductor when used as a choke blocks the flow of high frequency current (by presenting a high impedance), while allowing low frequency or direct current to flow through it.
Its function is to block ("choke") high frequencies while passing low frequencies.
This is the older term for an inductor, or coil of wire.
Chokes are used as filters, to form tuned circuits, and have other uses as well.
it is an inductor coil, tube lights need high energy for ionisation to takes place.thus it develops the necesary power for ionisation
The electrical abbreviation ( UH ) is a measure of inductance , as in a ferrite transformer core , inductors , choke etc. .
A choke coil is an inductor, which is designed to block a particular frequency in an electrical circuit while passing signals of very less frequency or direct current.
A choke coil is used in several electrical devices. The function it has is to block AC currents from passing through as it allows DC currents to pass through.
Key Specifications/Special Features:SMD toroidal choke coilLow DCR choke coilCommon-mode choke coilLarge-current choke coilLow profile choke coilHigh-reliabilityHigh frequency, low lossHigh-energy storage
Depending on the circuit, typically a combination of a coil (commonly called a choke) and a capacitor can be put in circuit at multiple places to significantly reduce noise in a circuit.
The choke enriches the mixture for start-up and then is heated by a small electrical heating coil so the choke goes off when the engine is at operating temperature.
The electrical abbreviation ( UH ) is a measure of inductance , as in a ferrite transformer core , inductors , choke etc. .
A choke coil is an inductor, which is designed to block a particular frequency in an electrical circuit while passing signals of very less frequency or direct current.
electric chokes work on heat and electrical power to do the adjustment, manual chokes YOU are the adjuster as you drive u move a choke knob for the adjustment.
A choke in electronics is used for blocking the higher frequency known as AC. When this occurs it allows the lower frequency known as DC to pass through the electrical conductor.
A choke coil is used in several electrical devices. The function it has is to block AC currents from passing through as it allows DC currents to pass through.
You need to take you car to a mechanic. It is obvious you do not know what you are doing. Your battery is in the electrical system. Your choke is in the fuel system. They are separate. It is normal to pull out your choke to start your engine. It is not normal to have your choke out to run your engine. As soon as your engine starts, you should push your choke in. When you pull out your choke, you close the air going into your carb. Then you push in the choke to allow air to flow through your carb. That lets you speed up or slow down. If it won't run with the choke pushed in, try pushing the choke in slower.
A fixed choke is a choke that can not be removed or changed.
A 454 Chevrolet engine which is experiencing a choke light while the choke is physically open, indicates the choke is not receiving power. This can be caused by a loose connection or a defective choke.
Battery discharged or low , Fault in the fuel of electrical systems , Choke inoperative , This question is hard to answer without knowing all the symptoms
The choke lever should be down for the choke to be off. In the raised position is choke on.
Yes