Sort Code 20-41-12 is:- Barclays Bank 5-6 High Street Hitchin Herts SG1 5BJ
HSBC harrogate
Hustlergate Branch, 45 hustlergate. Bradford. BD1 1NT
Wachovia Bank, N.A. 12 East 49th Street New York, NY 10017
The correct term is post meridiem (not meridian). "Post" means after, and "meridiem" is Latin for "mid-day." Therefore, post meridiem means after mid-day. In modern times, we use it to mean after 12-noon until midnight. By convention, exactly 12-noon belongs to P.M. and exactly 12-midnight belongs to A.M.
what does code 82 mean on meriva mean 12 plate
That code means that the computer system checks NORMAL. Unless there is other codes present after it flashes code 12 It will always flash code 12 FIRST.
Code 12 is just confirming that the computer is working. This code alone should always show when you test it.
You need to reset the clock.
Code 12 is a period It flashes when the codes start and end so you will see code 12 usually three times, then the codes you need to fix then code 12 three time and the codes you need to fix will repeat and so on.
1=Rotate tires and check air pressure and condition of tires. 2=Replace engine Air filter & Cabin filter, check drive belt.
code 12:problem with battery connection.direct battery input to PCM disconnected within the last 50 ignition key-on cycles. code 51:oxygen sensor signal input indicates lean fuel/air ratio condition during engine operation. code 46:charging system voltage to high.computer indicates that the battery voltage is not properly regulated.
Code 12 means that the computer has been reset.This code will always be ther no matter what you do.There is no getting rid of it.
12 is battery disconnencted recently 21 is oxygen sensor stays at center. 55 is end of message.
There is no code 91. The codes start at 12 and stop at 53.
The indication begins with the start code 12. After that a maximum of three code numbers appear in the order of the latest one first. The indication then returns to the start code 12 to repeat (the indication will stay on for five minutes at the most).In other words it will display code 12 to let you know that you are in diagnostic mode.
fault code 12 is that the battery has been diconected within the last 50 key-on cycles. fault code 41 is bad alternator. an open orshorted condition detected in the alternator field control circuit. get it in the shop!