Call around and get estimates from dealers and qualified independents. it is not going to be cheap for sure but the actual cost depends on where you live and if there was damage done to the engine other than just a blown gasket. The head could be warped or cracked. if you kept driving it then there will be other damage to contend with. Too many variables to proved an accurate answer.
Just like any other vehicle. The head must be removed in order to replace the gasket. There is no other repair for a blown head gasket except the replace it.
Depends, if only the gasket is blown. The head may be warped or cracked. Hard to give you a price because it also depends on where you live and who does the repair.
Some websites gives the solution for Repair shops in st cloud fl for 2004 mazda rx8
you may have a blown head gasket or a cracked block
GO TO AUTOZONE.COM FOR THE REPAIR INFO.
sound like a blown head gasket
Can't think of much else than overheating or a blown head gasket.
Where is it? Coolant is under 17-21 pounds of pressure be more specific
SOUNDS LIKE THE INTAKE GASKET BLEW, OR THE HEATER CORE FAILED.. EITHER WAY, THIS IS A COSTLY REPAIR.
if it is lowering oil and water both and is not leaking it may have a blown head gasket and it is going out the tailpipe
1,235$I have been buying cars and vans that have blown head gaskets for myself at a reduced cost and I have had great success repairing them without disassembling the engine. Its very simple to use and is a permanent repair. It costs 20.00 and its added to the radiator. It mixes with antifreeze and does work if you follow the simple directions. My cousin has a garage and has been using this stuff. Its very hard to find and is not found in part store's if you want any email me kerisvery@aol.comSealed up a blown head gasket and cracked block.Thanks Carl Shilanskis1995 corsica 3.1 with a blown head gasket, 3k miles and so far so good. Hope its stays that way. Fred
could be the front or rear bulb has blown out. if you have already changed one of these bulbs, be sure to replace it with the proper size