answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: What does it mean when diagnostic test says Intake Manifold Runner Stuck Closed?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you fix 2001 ford mustang P1519 code diagnostic?

P1519 = Intake Manifold Runner Stuck Closed (Bank 1).


2003 Ford Focus check engine code P1519?

Ford_OBD-II_Trouble_Codes" Ford OBD-II Trouble CodesFord OBD-II Diagnostic Trouble Codes. ... P1519? Intake Manifold Runner Control fault - Stuck Closed. P1520? Intake Manifold Runner Control fault ...


What will happen with the intake manifold runner stuck closed?

car wont run its like a carb if the choke is close the car cant breath


What does diagnostic code p1538 mean on a 1996 Ford Windstar?

Trouble code P1538 means: Intake Manifold Runner Control Stuck Open (Bank 2)


Wher is the intake manifold runner control valve on a 2008 Dodge Avenger?

Finding the intake manifold runner control on a Dodge Avenger is easy. It is located near the engine.


Where located intake manifold runner Jeep grand 2005?

The intake manifold, on your Jeep grand Cherokee, is located on the front side of the engine. The exhaust manifold is bolted to the engine.


Where is manifold runner located dodge caliber?

On the end of the intake maifold.On the end of the intake maifold.


What goes wrong with 2007 dodge charger When your short runner valve go bad?

Normal cause is the intake manifold itself.Normal cause is the intake manifold itself.


Where is the intake manifold runner control valve on a 2002 2.3 ford?

Try this for starters: http://www.youtube.com/watch?v=YgikQ8s6Va0 And then this: New Intake Manifold Runner Control Actuator (b99) = $72.47 +tax @ dealer. New Intake Manifold Runner Control (b999) = $127.00 +tax @ dealer. Dealer tech Labor = $450 +tax Good Luck


Where is the intake manifold runner on a 1999 ford contour se and is it hard to do yourself?

The intake manifold runner is on the lower intake manifold, under the upper intake manifold. As to how hard it is, well, it depends what you could possibly want to do to it. Unlike some Mustang's, removing the runner on the Duratec offers no benefit to high end performance, while reducing low end torque. If you have a stuck runner on the other hand, I cannot say, though there should be a lot of info on the contour enthusiast group over at contour.org


Where is the short runner valve on your 07 dodge charger?

They are inside the intake manifold.


Where is the intake manifold runner control on a 2006 Ford Fusion?

for the 2.3L 4 cyl. motor, it sits on top of the plastic intake manifold which faces the radiator.