It could mean many things. You will have to pull the codes to see which area to go after. But if no codes are present,you should suspect the wheel sensors. Go to salvage yard,get one,then go to each wheel,unplug it and plug in the one you just got.See if the light goes off.Be sure to turn off the key and back on after EACH wheel.
Either one of the door switches is broken or the dome light switch on the dash is turned on.
If coolant level is correct - could be a defective sensor
Ensure the light is switched to come on only if door open.
Charging problem, altenator going bad or has already gone bad.
If a 1991 Chevrolet S10 Blazer warning brake light always stays on, it could just be a malfunction of the light. To reset it, disconnect the battery for 10 minutes.
gage of temperature go to hot position but is not hot the engine check gages light come on
When the LED light on an aftermarket alarm stays on, it means that the alarm is active. The light generally shows that the alarm status is "ready."
When the airbag light stays on it usually means there is a problem with the system.
No. Not visably
There is a sensor either in the coolant recovery jug or the radiator side tank that is defective.
When the airbag light flashes and stays illuminated in grain, means the air bags our operational. When the symbol is illuminated in red, the airbags are not operational.
It is probley a wheel senor that is bad, Need to scan ABS system to locate problem,