I guess you mean the ratio of the areas; it depends if the 2 rectangles are "similar figures"; that is their matching sides are in the same ratio. If they are similar then the ratio of their areas is the square of the ratio of the sides.
20 girls to 1 guy
The ratio of the circumference to the diameter of a circle. (3.14159265358979323846264338327950288...)
a ratio table is a way of presenting a ratio on a math table ratio is just another word for verses. for ex. if their are 23 dudes and 55 dudettes the ratio would be 23:55 so the graph would have a higher bar for the dudettes compared to the dudes
suck my big black dick math and get a LIFE!
The ratio for a simple pulley (not a pulley block), using an inelastic string, is 1.
the circumference ratio
Drive Pulley = pulley on motor Driven Pulley = pulley on blower First determine your Ratio - divide large pulley size by small pulley size this will give you gear ratio, Example 2" drive pulley and a 4" Driven Pulley = 2:1 gear ratio If you know your motor shaft RPM divide that number by the ratio to get the RPM of the driven pulley, if your shaft rpm is 1800 rpm you would divide 1800 by 2 which would = 900 rpm on your driven pulley if your drive pulley is larger than than your driven pulley you multiply the rpm by the ratio example 1800 rpm x 2 = 3600 rpm
to avoid the slip , increase the velocity ratio and increase belt and pulley life... thanku..:)
A ratio that is the number of falls of rope in the system, apart from the rope between head-pulley and winch or you.
1:2
To find the velocity ratio of a pulley, you must first find the effort and load distances. then you divide the two and there you have you VR (velocity ratio).
it mean that the pulley which is a machine that pull stuff has force that fixed the pulley ":"I THINK:""
It depends which "pulley" you mean. Drive pulleys are on the front of the engine.
If you mean the pulley and the shaftit is mounted on, Yes! A loose belt on the pulley doesn't necessarily mean anything but a need to adjust the belt tension.
I'm assuming you mean a pulley, which is what the belts run on. If so, depending on which pulley the bearings could be bad or if it is the crankshaft pulley (big pulley near the bottom) the rubber could be getting bad.
If you mean the power steering pump pulley, then rent a power steering pump pulley puller tool from Autozone. It does not screw off, the pulley is pressed onto the shaft.