Its a traction control switch...when your slipping usually your tires spin when traction control is on it lets the other tire spin just as fast so you dont slide as much and get more grip. Use this when the roads are hazardous, snow rain etc.
No, not if it is not defective. If the ignition switch is defective then that is all you need to replace.
The headlight of yourÊ2003 Sunfire is probably dimming because the bulb is dying. ÊYou will need to have this bulb replaced.
Try the fuel pump, it may need to be replaced.
To change the reverse lights on a Pontiac Sunfire you need to locate it on the left side of the transaxle. Then, unplug the electric connector and remove the switch along with the socket.
The brake light switch is located on the brake pedal bracket. You'll need to remove the trim panel beneath the steering column to get to the switch and the connector. FriPilot
The brake light switch is located on the brake pedal bracket. You'll need to remove the trim panel beneath the steering column to get to the switch and the connector.
The 2003 Cadillac Escalade does not have an inertia switch. These most often need to be reset after a new fuel pump is installed.
It's in the hazard warning switch. You need to replace the switch.
The Fuel pump is in the gas tank.. You will need to drop the tank to fine the fuel pump..
I have had much experience with this problem. You will need to buy a new headlight switch assembly and find where the headlight wires are shorted. I just replaced the switch but it kept burning out. It wasn't until later that I found the short in my headlight wires behind the driver's headlight where the wires come through the rad support. Happy hunting.
It sounds as if you have a defective ignition switch. The next time it happens you need to turn the key slightly. If it starts working then the ignition switch is bad.
i need to know when fuel switch is pointed up is that for reserve or for full