answersLogoWhite

0


Best Answer

The control valve purpose is only to release any water from the crankcase if the jetski has been underwater, and water got into the engine.

User Avatar

Wiki User

9y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What does the control valve cable do on a kawasaki jetski 750?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where can i get a float valve assembly for my kawasaki ke 100?

You can get the float valve assembly for your Kawasaki KE 100 on Ebay.


What is the valve clearance of kawasaki 175?

The correct valve clearance for kawasaki 175 is 0.06mm for intake and for the exhaust is 0.08mm


What are the valve settings on a kawasaki 25 HP OHV engine?

what is the valve setting on a 25 hp kawasaki lawn mower engine


What is the correct clearance of valve intake of kawasaki barako?

the standard valve clearance for kawasaki barako is 0.08mm for intake and 0.10 for exhaust


What does the heater valve do?

The heater control valve is used to shut off hot coolant from entering the core when the heater is in the off position. A heater control valve can be actuated by either a vacuum line or a cable from the vacuum heater control valve to the heater core. This hose should be warm; if not the heater control valve is stuck and needs to be replaced


How do you adjust a choke on a 1994 750 Kawasaki Jet Ski?

Loosen the cable at the carb and hold the choke valve wide open. Then tighten the cable. Check to make sure it closes all the way when you pull the choke lever.


Why is my 1996 Lexus ls 400 heater not working?

most likely cause is the heater control valve under the hood on the passengers side near the firewall. Look at the control valve and cable for a crusty dry residue leaking from valve onto cable. If there are signs of a leak the fluid tends to travel down the cable causing it to seize. Once this happens the servo bends the cable on the inside of vehicle. It is very easy to replace the valve and cable, but make sure you tape the cables together to help feed the new one through.


Were is the heater control valve in a 2001 dodge diesel?

The heater is controlled by the same panel as the fan switch. The temperature is controlled by a cable that moves an airflow control door inside the HVAC housing. There is no water control valve if that is what you are looking for.


Car stalls when put in gear?

if its a manual then it could be three things, clutch cable or throttle cable, or IAC (idle air control valve) but if its an automatic it could be throttle cable or IAC.


Where is the idle control valve on a corsa B z10xe 1.0L engine?

The icv is located next to the rev cable.


What is the valve clearance for a 96 Kawasaki bayou 400 4x4?

valve adjustment on 400bayou 1999


Where is the heater control valve in a 1986 Olds 98 Regency Brougham 3.8 with auto temp control?

It is at the rear of the intake manifold, follow the heater hose. there is a flow door under the dashboard with a cable connected is that the control or does the valve body at end of intake still control it?