power in, and power out--input and output.
ideal transformer is that which has no power losses.if any transformer transfer power to secondary without power loss then that call a ideal transformer
No. In an amplifier, Power Out > Power in. In a transformer Power Out ~= Power In (minus internal losses). An AC generator is more like an amplifier than a transformer.
A power transformer is used to provide power (to your home, for example), an instrument transformer is used to measure voltage or current (for metering, for example).
You cannot 'change' the 'rated power' of a transformer except by changing the transformer for another one. You can, though, operate the transformer below its rated power or, for short periods of time, operate the transformer aboveits rated power.
The three main reasons for the widespread use of transformer are power outage, more power supply and sustainability among consumers. This is what has made the transformers to be much appreciated.
ideal transformer is that which has no power losses.if any transformer transfer power to secondary without power loss then that call a ideal transformer
The ratings state the limits on voltage and current for operating the transformer at full load. The rated voltage times the rated current gives the rated VA of the transformer. Transormers are not usually rated directly for power because this depends on the power factor of the load applied.
No. From what you're saying you're taking the input to the 2kV transformer in a microwave and replacing it with a 1MW input. The transformer will burn in milliseconds of power. <<>> The installation and maintenance of a 1000 KVA transformer can be worked on in a de energized state. To do so live could be extremely dangerous at any voltage.
rectifier transformer converts acinto dc.but,power transformer convert step up or step down ac energy without changing frequency
Transformer Inductance?
B.I.L. stands for Basic Impulse Level for the transformer. It should be on the faceplate of the transformer.
It isn't! A transformer operating at no load has a very low power factor.