its a 2000
With a scan toolWith a scan tool
With a scan tool.
you buy a reset tool from parts shop
After repairing the cause of the code, you clear with a scan tool.
you need to take it to a dealer and have it serviced or buy a resetting tool.
The only way to clear the service light is by using a scan tool on the newer models.
To reset the SRS warning light on a Mercedes Vito, an OBD scan tool is necessary. Open the fuse panel and plug the OBD scan tool into the port. Turn the ignition key on and write down the codes shown by the tool. Check these codes in the user manual and have the appropriate repairs made.
To change the side mirror glass on a 1999 Mercedes Benz C280, first, gently pry off the plastic cover and remove any screws holding the mirror in place. Then, carefully detach the old glass from the mirror housing by releasing the clips or using a flat tool. Once removed, attach the new glass by aligning it with the clips and pressing it into place, ensuring it’s secure. Finally, replace the plastic cover and any screws you removed earlier.
You insert a screwdriver into the bottom of it and pry it open. It does not come off, but hinges open, allowing you to insert the jack. If you don't have a screwdriver, there is a tool in the toolbag that comes with the car, usually located inside of the spare wheel.
Use a Mercedes specific or OBDII generic scan tool.
The oil filter is located behind the engine. Between the engine and the firewall. Sometimes, you will need a special tool, like a cup of coffe to unscrew, sometimes you will need only your hand. Be careful with a lot of wires. Not to dissconect some of them when you try to pull the filter out.
It's a tool that helps you adjust the timing of your engine.