Want this question answered?
The crown of the weld is the material of the filler metal that projects above the surface of the parts being joined by the weld.
Filler rods are used to add metal to a molten weld pool during the welding process and electrodes actually have electricity running through them to deposit metal into the weld with the exception of TIG welding where the tungsten electrode is used solely for heat.... Hope this was helpful
Use Hastaloy X
I have experience when my team welded "JIG Ladle" A36 to AISI 4140, we used electrode E7018 with SMAW process. The important thing for this welding's prehating during welding min. 180 degree celcius and did peening the weld beads to minimize residual stresses. After welding covered by blanket for slow cooling. Regards, Asep S (asep93st@yahoo.com)
You can use the 308 or 316.
filler rod Almost all metals produced can be welded. Electrodes/rods of similar or compatible metals are manufactured to weld these metals.
A fusion weld has no filler material. The pieces to be joined are touching and heat is applied at the joint. The edges melt and "fuse/weld" together. TIG or Oxy-fuel Welding is used. This type of welding is considered to be pure as nothing is added to the weld.
while doing the welding ,the weld metal should be deposit in the weld pool of parent material and electrode.In some type of welding like TIG ,the electode is not consumable ,it is used to create arc betwenn the electode and the parent material.In such cases,the filler metal or wire is used to join the parent material
It is a weld made by melting the edges of the materials to be joined, but adding no filler metal to the weld.
Most material being welded to 2205 including itself, should be welded with 2209 filler wire.
TIG uses tungsten in a gun and electricity to melt the material, the user must manually add filler rod. Needs shielding gas Mig uses a gun, but the filler rod flows out of the gun. Electricity flows from tip of wire into material. needs shielding gas except with flux-cored wire. SMAW uses pre fluxed electrodes. electricity flows trough electrode holder, into material when material is scraped by electrode. No shielding gas. Oxy-fuel. Flame welding. Oxygen and a fuel (acetylene, propane, mapp, etc.) are mixed in a torch, ignited, and used to melt material. filler wire is manually added. There are more indepth explanations, and advanced machines, but that is the basics.
A heterogeneous weld corresponds to a weld that is realized with a different filler alloy than the base metal. At the opposite, a homogeneous weld is realized with same filler alloy than the base metal. Finally, an autogenous weld is done without filler alloy. The joining is realized by melting only the base metal. A.B.