0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What is the force that is exerted on a A kg mass to give it an acceleration of A meters per second squared?
Force = (mass) x (acceleration)You want both mass and acceleration to be 'A'.Force = A times A = A2 newtons.I guess that means that if you have a rock with mass 5 kg and you push it with force (5)2 = 25 newtons,it'll accelerate at 5 m/s2.
How much force it needed to accelerate a 25 kg bowling ball at?
(25) times (desired rate of acceleration) Newtons.
What is the density of helium at 25 degrees celsius and one atmosphere of pressure?
WATER
How much force does it take to brake an egg?
25 newtons or 6 lbs
What force is needed to give a .25-kg arrow an acceleration of 196ms2?
49N
What is the total force on an area that is 4 inches by 8 inches if a pressure of 25 psi is?
Pressure is force per unit area and force is the pressure over the total area Here pressure is 25psi This acts on an area 4inch x 8inch = 32square inch So total force is 25 x 32 = 100 x 8 = 800 pounds
Equal weights of methane and hydrogen are mixed in an empty container at 25 degrees Celsius The fraction of the total pressure exerted by hydrogen is?
1/2
A 25 kg suitcase is being pulled with a constant speed by a handle that is at an angle 25 above the horizontal if the normal force exerted on the suitcase is 170 N whats the force applied to handle?
use the formula N=mg+F(sin theta). plug in the givens and solve.
How much force does the atmosphere exert on a rectangular box that is 10 by 20 by 25cm?
Surface area of a box: 2ab+2ac+2bc = 2*10*20+2*10*25+2*20*25 = 1900m2. At sea level, atmospheric pressure is 10N/m2 So this means a total of 19,000N of force is exerted on the box. These forces however cancel each other out, those 19,000N have no effect on the velocity of the box.
How do you to select a pneumatic hammer which can give 25 g force?
It depends on air pressure in the pneumatic system. You pneumatic systems for high and low air pressure to force change. This is the compressor power.
How much pressure can an eggshell withstand?
An eggshell can withstand a lot more pressure than people think. It can withstand the force of 6.2 pounds or 25 Newtons.
What in peak inspiratory pressure?
The maximum pressure exerted against the patients airway during the breath.
What is the force that is exerted on a A kg mass to give it an acceleration of A meters per second squared?
Force = (mass) x (acceleration)You want both mass and acceleration to be 'A'.Force = A times A = A2 newtons.I guess that means that if you have a rock with mass 5 kg and you push it with force (5)2 = 25 newtons,it'll accelerate at 5 m/s2.
Use this formula to compute the pressure of air pushing down with force of 25 newtons over an area of 5 meters?
5
What is the gradient called that is the driving force for the movement of water and dissolved solutes from the arterial ends of blood capillaries?
The blood pressure in the capillaries at arterial end is about 25 to 30 mm of Mercury. The oncotic pressure of the plasma proteins is about 22 mm of mercury. So there is net force, which drives out the fluid in the interstitial space. The fluid is sucked back at the venous end of the capillaries by the oncotic pressure of the plasma proteins. It should be called as pressure gradient.
What is the principle or theory behind this dead weight gage tester?
Dead weight testers are named so because they utilize dead weights in determination of pressures operating in a closed and compressed fluid system. They are so called because of the reason that for each value of pressure to be exerted/ applied in the closed hydraulic system, a predetermined / fixed amount of weights are used to exert the force to counter balance the buoyancy forces. Each weight is stamped with the equivalent amount of force that will be exerted on a predetermined area of piston cylinder arrangement by using that weight. There fore the device is called Dead Weight tester. Working Principle: DWT (Dead Weight Tester) works based on the principle of Pascal's law. The law states that in a closed system of incompressible fluid, the pressure applied will exert equal amount of force in all the directions. In DWT system, silicon oil is used within the closed boundaries of the Piston cylinder arrangement, piping, pressurisation chamber and in the head on which the gauge to be tested/ calibrated is fixed. The oil is taken in to the pressurisation chamber from oil bowl and all the air entrapped is vented off. This is because of the reason that air is compressible and hence do not allow pressure to be exerted equally in all the areas and there by create error in the test results. Once the system is full with air free oil, pressure is gradually increased from the pressurization chamber. Oil pressure starts increasing in all the areas including piston cylinder arrangement over which the dead weights are mounted. As the force increases gradually and equals the amount of down ward force being exerted by the dead weights, the total system gains the state of equilibrium and just at that moment, the dead weights starts getting lifted up. At this condition, the amount of force operating in the entire system is same. The sum of pressure values stamped on weights lifted is operating on the pressure gauge element also, which is under test/ to be calibrated. Necessary corrections are made in the zero/ span adjustments in gauges/ Pressure transmitters. Above sequence is repeated for all the values at 0%, 25%,50%,75% and 100% to check for linearity and repeatability. This is how the DWTs are working.
What is the force that static friction can exert on oa object that is moving 15 kilograms west and 25 newtons is being exerted?
"Static friction" refers to objects that are NOT moving.The amount of friction depends on the so-called "coefficient of friction", which varies depending on the properties of the surfaces that are in contact.
