10 AWG.
No. A 20 amp breaker needs 12 gauge wire.
No, 10 gauge wire requires the use of a 30 amp breaker. A 20 amp breaker is only used on 12 gauge wire.
A domestic D/W uses 14 gauge wire.
Use AWG # 6 wire.
You listed no gauge wire. This is the required breakers.14 gauge - 15 amp12 gauge - 20 amp10 gauge - 30 amp8 gauge - 40 amp
You need a 60 amp breaker.
No. A 20 amp breaker needs 12 gauge wire.
First impressions would be failure in the compressor internal circuitry, wire gauge too small, outlet underrated, and/or breaker size to high for compressor rated load. Additionally, a loose connection at the outlet could have caused arcing.
No, 10 gauge wire requires the use of a 30 amp breaker. A 20 amp breaker is only used on 12 gauge wire.
A 20 amp circuit with #12 gauge wire will work in any event but if the nameplate recommends a 15 amp circuit then #14 gauge wire on a 15 amp circuit is sufficient. In either case you will have a double pole breaker and your equipment may not require a neutral. Always run a grounding conductor.
You need a 3 conductor wire with ground. For example if you had a 30 amp breaker for that outlet you would need 10awg 3w/ground. That's 10 gauge 3 conductor with ground and replace the old wire back to the panel.
You find a space in your electric panel that will hold a 30 A breaker. You run 10 gauge wire from the electric panel to where you mount the outlet. You buy a 30 A rated outlet with a receptacle that matches the cotton candy machine. Black wire goes to the brass colored screw on the outlet, white wire to silver screw and ground wire to green screw.
A domestic D/W uses 14 gauge wire.
Use AWG # 6 wire.
AWG 12.
10 guage.
15 amps