Want this question answered?
Increased The time constant of an "RC" circuit IS RC. So it's directly proportional to 'R' and also directly proportional to 'C'.
You can get the cheapest carbon fiber rods for RC foam planes at rcfoam.com.
Mind flip RC
Pheophytin or phaeophytin (abbreviated Pheo) is a chemical compound that serves as the firstelectron carrier intermediate in the electron transfer pathway of photosystem II (PS II) inplants, and the photosynthetic reaction center (RC P870) found in purple bacteria. In both PS II and RC P870, light drives electrons from the reaction center through pheophytin, which then passes the electrons to a quinone (QA) in RC P870 and RC P680. The overall mechanisms, roles, and purposes of the pheophytin molecules in the two transport chains are analogous to each other.
You can purchase a remote control Rock Crawler online at CKRC Crawlers website. Radio Shack sometimes keeps RC Rock Crawlers in stock, but buying online is a safer option to be sure you are satisfied withy our purchase.
Rc is an abbreviation for the Rockwell Hardness Scale, used to determine the harness of materials.
that depends on what your trying to make
440C Steel can be hardened upto 58RC unlike D2 (SKD11) which is upto RC 60 Hardness.
If youre looking for hobby grade, hobbyking.com but if you're looking for toy grade, then I dont think you can.
There are tables that give you the Tensile Strength based on a Rockwell Hardness test of a specimen of metal. For example: Rc of 54 is a Steel of TSU = 300,000 psi. Google the internet for Rockwell Hardness Table.
Lego, Tyco, New Bright, Nikko
RC stands for Rockwell Hardness C scale; the different letters A,B,C etc. are based on different loads and indenters for measurement. C scale is typical for steels, while B scale is typical for aluminum. There are conversion tables for these if needed.
For a good hobby grade truck look to spend about 150 and up for electric and 300 and up for nitro
D-2 is a tool steel that is supplied in the annealed or soft condition. This grade must be hardened after machining . D-2 is heat treated between 1825 to 1875F. After heat treating, the tool steel will attain a hardness of about RC 62-64. However, after hea treating, the steel is very brittle and must be tempered. Below is a list of common temperatures for D2 try this......Tempering °C150200250300350400HRc62/6161/6060/5957/5656/5556/55See the related links for the D-2 tool steel data sheet and an introduction to the heat treating process.
S7 tool steel is produced and supplied to the machinist or tool maker in the annealed or soft condition. S-7 is typically heat treated and used in the Rockwell C hardness range of RC 54-59. Form more specific information about S-7 tool steel and heat treating, see the related links below.
Tool steels are compared to each other. They are usually measured by toughness, hardness and wear resistance. The toughness is detemined by an Charpy impact test. The hardness is measured by a Rockwell hardness tester and reported as HRC or RC. The wear resistance is measured by a number of tests that measured the amount of material removed from the original size after a repetitive movement against an abrasive material. These figures are then gathered and presented on a chart. The grades are then compared with one another based on these three properties. See the links below for more information on comparing tool steels.
S7 tool steel is produced and supplied to the machinist or tool maker in the annealed or soft condition. S-7 is typically heat treated and used in the Rockwell C hardness range of RC 54-59. Form more specific information about S-7 tool steel and heat treating, see the related links below.