here are some information about oils.
you can use multigrade oil 20W 50 or 20W 40, API SH or API SJ. and your oil change interval depend on your cars engine condition and the fuel consumption.
please read the following for general information.
Please refer to the API Classification.
S for Service, SE, SF, SG, SH, SJ and SM
C for Commercial. CD, CE, CF, CF-4 etc.
The higher the classification grade the higher the lube oil quality and the longer you can use the oil.
The less fuel consumption the longer the lube oil change interval.
well actually the lube oil change intervals are dependent on many factors, the engine condition, Oil grade and the fuel consumption.
so basically you can use any of the above oil but your lube oil change interval will depend on what grade you select, fuel consumption and engine condition.
Please select the right viscosity for your climate, winter grade will be better for all climates. There are single viscosity and multi - viscosity grades.
SAE30, SAE40, SAE20W 40 etc W here stands for winter and the operating climate temperature range is between -20 to 40 degree Celsius.
API oil grade reference:
http://www.le-international.com/uploads/documents/051_Current%20API-SAE%20En
The grade of oil your vehicle uses is determined by what geographical area you live in. The colder the weather the thinner the oil. The warmer it gets the thicker the oil. Most vehicles use 10-w40 grade Motor oil. Your handbook will have the specific grade that your car needs to use.
I NEVER USE A MULTI GRADE OIL I USE A STRAIGHT 30 WEIGHT DETERGENT
If the manufacture recommends the use of an Xw40 viscosity grade it should be fine. The same if an Xw30 viscosity grade is recommended but the engine is well worn. Consider also the quality certifications as well as the viscosity grade before choosing to use the oil in this application.
Depends on what engine is in this car. Use the 5W-40W grade fully synthetic engine oil. For gasoline engine check that the oil is A3 spec. For diesel engine, it should be B3 spec.
It is important to use the correct type of oil in a car to keep the engine running properly. For this particular car, it is recommended to use a 5w-30 oil.
10w30
5w30
It takes Exactly 8.5 quarts when performing a Oil & Filter Change. And you must use 0W-40 Grade Oil.
Oil changes will improve your engines performance. You should complete an oil change at least once per year , when you have your car serviced. Ensure that the oil used is of the highest grade and is the recommended grade for your vehicle. If you drive in normal conditions then change your oil/filter every 5,000 miles if you use conventional oil or every 8,000 miles if you use synthetic oil.
SAE 5w30 weight oil is required.
As recommended by the manufacturer. Your driver's manual will have that information.
it should be 10/30