0
What happens if the electrical connector is not connected to the ac compressor?
Wiki User
∙ 14y ago
The a/c clutch will not engage and the compressor will not come on.............
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
What happens to an electrical circuit when there is unwanted resistance in it?
a common cause of this type problem is corrosion at a connector.
If an insulator with a lamp is connected in a electrical circuit The switch is turned-on What happens?
Please re define "If an insulator with a lamp"
What happens when heavy loads are connected to an electrical generator?
If the load is too heavy the voltage droops because of the drop across the generator's internal impedance.
How to manually kick on compressor for a 2001 Saturn L200 AC?
There is a protection device on the AC system that prevents the AC compressor from destroying itself. If the AC compressor runs when there is no refrigerant present, friction inside the compressor will wear out the moving parts and push little pieces of worn compressor through the entire AC system. Once that happens, a simple recharge of the refrigerant changes into a major repair of the entire system. So the protection device turns the compressor off when the refrigerant drops below a set pressure as determined by the protection device. But if you insist on forcing the compressor on, there are two ways: 1. Find the protective device. Depending on the system, it can be on the receiver/dryer or anywhere else on the low side of the AC refrigerant lines. It will be the only sensor on the low side refrigerant lines Put a jumper across the low side sensor, then turn on the AC and the compressor should work, provided that everything else is functional. 2. Examine the front (pulley end) of the AC compressor. There should be a connector with a single wire. (if there are two wires, one will be connected directly to chassis ground If you connect a jumper wire directly from the battery to that connector, the compressor clutch should engage immediately. Neither method is recommended unless you know what you're doing and/or are in the process of recharging the system.
What happens to a 220v 50Hz air condition when connected to a 220v 60Hz supply?
The compressor may run slightly faster, but little else. You should get away with it without damage. Any timer circuits may be inaccurate.
What happens if you hold a compressor hose to your skin?
This is dangerous and must not be done.
Why air conditioning compressor clutch engage and disengage every second?
This happens to keep the fluid in the compressor viable. If it sits too long, it can become unusable.
What happens when you unscramble the word 'cleerlicat'?
You can make ELECTRICAL !
What happens when electrical energy is added to water?
When electrical energy is added to water it creates electric shock.
How do you clean EGR valve 05 Chrysler 300?
It is best to replace it. The failure happens in the electrical part of the valve, not the pintle and seat.It is best to replace it. The failure happens in the electrical part of the valve, not the pintle and seat.
Can there be a tie connected to a note then connected to another note?
Yes; this happens when for example, the notes change and/or are in different measures.
What happens without automatic air tank drains?
You would have to use a cycling clutch air compressor connected to pressure sensors in the tank. Otherwise, the tank would overpressurize and rupture. The problem with this method, aside from it being excessively complex, is that it leaves no means to drain moisture out of the tank.
