execute 'netstat' command as root user. other wise it won't list PID/program
Your dum to not no the answer.
Information used are the source port number, the destination port number and ip addresses.
A frame with the destination MAC address of Router_A A packet with the destination IP of Server_B.
an arp (address resolution protocol) comes into picture when we have the ip address of our destination but we dont know the mac address of our destination.Normally when we open a web site this is the process which takes place.IP packet transmission comes after arp when the destination mac address is obtained after arp request.so an ip packet contains both source & destination IP & mac addr.
The destination computer will likely send back an ICMP Destination Unreachable message to inform the source computer that there is no process listening on the specified port. The source computer can then take appropriate action based on this response, such as notifying the user or terminating the connection attempt.
the process is called jumping.
The server adds the source and destination IP address to each segment header to deliver the packets to the destination.
The server adds the source and destination IP address to each segment header to deliver the packets to the destination.
conception occurs when a sperm cell successful attached itself to an female's egg. And the process of its rolling down the fallopian tube. conception occurs when a sperm cell successful attached itself to an female's egg. And the process of its rolling down the fallopian tube.
Most protocols issue a special error messagethat is sent back to the source in this case.
According to Biologists, the process in which oxygen becomes attached to RuBp which is fixed is known as photorespiration. This process does not apply to carbon dioxide.
The stages of destination planning are; Situation Analysis Planning Process Ongoing Engagement