Want this question answered?
Current in a circuit can be measured by using a device called ammeter that is always connected in series in the circuit in which current is to be measured.
The current (amps) will remain constant, but the voltage will drop.
"ammeter"
the same In a parallel circuit, the voltage travels through all the closed circuit paths. They are not branches.
D.c GeneratorComputers=======================DC voltage is measured with a voltmeter.DC current is measured with an ammeter.That's all there is to measure in a DC circuit.
that is what im asking you
You have to measure the voltage, and the current. The resistance is then calculated by using Ohm's Law.
To measure the current in a DC circuit an ammeter may be used. This ammeter may consist of a sensitive meter with a shunt in parallel with it to divert part of the current. In case even more current is expected than the full scale reading of the meter an additional shunt may be connected in parallel with that arrangement.
SMOKE!!! Yiii-haaaa! An ammeter is always as low a resistance as possible. That way, the current that you measure in a circuit using the meter will be the same as if the meter were not there. So putting an ammeter in parallel with a circuit means that you just short circuited the circuit you were intending to measure. Poof! There goes your ammeter!An ammeter has a very low internal resistance. So, if it is connected in parallel with a load, it will short-out that load. The resulting high current flowing through the ammeter may severely damage the meter (and possible harm the user), although most are fitted with fuses to protect them.
In shortg circuit current is infinitive.
To measure the current in the circuit an ammeter is used and it is connected in series
A current flows through, not across, a circuit. And, yes, you can measure it using an ammeter.
To measure current in circuit
Because its function is to measure the current, i.e. the amount of electrical flow in the circuit, and this require that the current flows through the ammeter A good ammeter has very low series resistance, so connecting it in series will not affect your circuit. Be careful when using an ammeter , because of its very low resistance , it can cause a short circuit if you use it by mistake to measure "voltage", so avoid connecting it in Parallel.
The voltmeter is connected parallel to the circuit in order to measure the voltage drop across that circuit or sub-circuit. If you were to connect the volmeter series to the circuit, since it is a high impedance device, it would represent an effective open-circuit condition. You would see the voltage available to the circuit, but the circuit would not receive its intended current and it would not function. Contrast this with the ammeter, which you do place series to the circuit in order to measure the current flow through the circuit.
The voltmeter will register the volts, the ammeter will either explode or blow a fuse since it has a very low resistance and is designed to be used in series to measure the current flowing through it.
A voltmeter does not measure current, it measures voltage in units named volts. An ammeter measures current in units named amperes or amps in common shorthand. A voltmeter is connected in parallel to the circuit being measured, whereas an ammeter is connected in series with the circuit being measured.