answersLogoWhite

0

fuse blows, breaker trips, wire burns. if the latter is in your house, a smoke alarm is disireable.

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

How do you know an electrical circuit has a short in it?

A short circuit is determined by a low resistance between two conductors or between a conductor and the ground. <<>> The circuit's over current protection usually trips resulting in the circuit having no power.


What does breaking the tab on an outlet do and how does it affect the electrical circuit?

Breaking the tab on an outlet separates the top and bottom outlets, allowing them to be controlled by different switches or circuits. This affects the electrical circuit by providing independent control over each outlet, enabling more flexible use of the power source.


How can I remove a 3-way switch from my electrical circuit?

To remove a 3-way switch from your electrical circuit, first turn off the power to the circuit at the breaker box. Then, unscrew the switch plate and remove the screws holding the switch in place. Disconnect the wires from the switch, making note of their placement. Finally, cap off the wires with wire nuts and install a blank cover plate over the electrical box.


When you turn the key to start the car it will not turn over and there is no power to anything?

It is most likely a dead battery, especially if there is no power for lights or the radio. Check and clean the battery terminals because corrosion can break the electrical circuit.


What is electrical power measurement?

over 9000


What is the effective voltage of the electrical circuit?

The effective voltage of an electrical circuit is the measure of the average voltage over a complete cycle of alternating current. It is also known as the root mean square (RMS) voltage.


What is the relationship between capacitance and current in an electrical circuit?

The relationship between capacitance and current in an electrical circuit is that capacitance affects the flow of current in the circuit. A higher capacitance means the circuit can store more charge, which can impact the current flowing through the circuit. The current in a circuit with capacitance can change over time as the capacitor charges and discharges.


How does AC power work in electrical systems?

AC power, or alternating current power, works in electrical systems by constantly changing direction, flowing back and forth in a circuit. This flow of electricity is generated by power plants and transmitted through power lines to homes and businesses. AC power allows for efficient distribution of electricity over long distances and is used to power a wide range of devices and appliances.


The first measure you should take to help prevent damage against electrical problems is to do what to the circuit?

Protect the circuit with an OCPD, an over current protection device, such as a circuit breaker or fuse.


What happens if you overcompensate with 20mF capacitor for the inductive circuit instead of 10mF capacitor which already satisfy the power factor to reach 0.95?

there would be no problem with this == == The inductive circuit has a 'lagging' power factor. If you over-compensate with too much capacitive reactance, you could go over the top (past 1.0) , and end up with a leading power factor that may even be numerically worse than when you started. == == == ==


Over current relay?

in electrical circuit current will increase specific level (full load current).its call over current


What happens when there is to much current in a circuit?

If you are talking about the circuits load being to large for the circuits capacity, then the circuits over current or over load protection will come into effect. The fault will open the circuit, thereby isolating the load from the electrical supply source.