Want this question answered?
Use a rheostat to lower the voltage to six volts
The phone will never charge.
Unless the ballast is a multi tap primary you can not rewire it for 220 volts.
No, use a fuse rated for the proper voltage.
Small pick up trucks use a 12 volt system. Large highway trucks use a 24 and sometimes 36 volt system, depending on the lighting load that is connected.
Probably not much because 6 Volts is not enough to power a 12 Volt coil
No.
Car Bomb
If you are talking about a 6 volt coil, yes, so long as the contacts are rated for the 230 volt circuit. If you are talking about 6 volt contacts, no, absolutely not.
Use a rheostat to lower the voltage to six volts
Most cars use a 12 volt system. Most cars built before about 1956 used a 6 volt system. Some, very few, use a 24 volt system.
The phone will never charge.
no volt release coil is use for basicali magnetising & when over current is flowing it will demagnetising propus
probably an old style 6 volt coil with an old-style 'lantern=battery' (6 volt) big fat square thing with the springs on top or old style 12 volt coil with like gas lawn mower key-start (completely sealed) battery /has male tabs/ on top. but coil will not hold a charge for later use.
Unless the ballast is a multi tap primary you can not rewire it for 220 volts.
You could burn out the device you're powering.
IT doesn't use one. The engines use a coil on plug system.IT doesn't use one. The engines use a coil on plug system.