This depends if the component was wired in series or in parallel to the rest of the circuit. When a component breaks, it stops functioning and cannot conduct electricity. If it is wired in series to the rest of the circuit, the entire circuit will cease functioning. If it is wired in parallel to the rest of the circuit, the circuit will continue functioning, but with more electricity going to the other line.
In a parallel circuit, when a component breaks, the current flow through that component will stop, but the other components will continue to function normally. This is because each component in a parallel circuit has its own separate path for current to flow.
Assuming that the break is in one of the parallel wires, the potential (v) across the parallels remains the same, the current (i) in the other parallel parts also remains the same, entirely dependent on the resistance (r) in the unbroken parts of the circuit. The current in the wire before the parallel parts of the circuit will be reduced proportionately because there is no current flowing through the broken wire any more. If you apply the equation v=ir ( or i=v/r) you can work out the current at any point in the circuit.
The voltage across the open branch will be 0V
The circuit would become open. (open means off)
Cutting a wire in an electrical circuit has the same effect as putting a switch into the off position - thereby creating a break (gap) in the circuit.
it won't flow
A series circuit is a circuit in which there is only one path for electrons to follow. In a series circuit, all components are connected end-to-end, providing a single pathway for the current to flow through each component in sequence. If any component in a series circuit breaks, it will interrupt the flow of current through the entire circuit.
Continuity in a circuit means no breaks; continuous.
The second bulb will also turn off since removing one bulb breaks the circuit, disrupting the flow of electricity to both bulbs. The circuit needs to be complete for electricity to flow and illuminate the bulbs.
It breaks
Because the vibration that happens between the floor and the dish.
A break in an electrical circuit will cause the circuit's load to stop operating.
The circuit stops working because of the short circuit
It is called an open, incomplete, or broken circuit. Circuits might be opened intentionally (using a switch), or unintentionally (breaks in, or disconnected wiring).
A parallel circuit is used in a strand of Christmas lights so that if one bulb goes out, the rest don't. A parallel circuit is also used in circuit breakers of houses. A series circuit is used in a flashlight. Everything follows one path.
The shorter end of each parallel line breaks off and falls to the floor with a soft 'clink'.
The failed bulb breaks the circuit so no current can flow - so the other bulb goes out (but is OK).
Removing any bulb breaks the continuity of a series circuit, stopping the flow of electrical current. Removing a bulb in a parallel circuit does not interrupt the current flow, so the remaining lights continue to conduct electrical current.
Adding more lamps in parallel (across) a line will cause total current to climb. It will keep climbing (increasing) until a load protection device (circuit breaker or fuse) breaks the circuit or until something fails because of excessive current.
When a fuse blows, it essentialy breaks the circuit. So the current can no longer flow, this is used as a safety measure.
Both are same. Only thing it depends upon the incoming voltage. In series ciruity if one bulb fails, the ciruit continuity breaks . In case of paraleel circuit even if one bulb fails the circuit continuity will not get affected
series circuits have the load wired one after the other parallel circuits have the loads wired on different branches-the advantage being if a bulb breaks, or another component, the others still have current flowing through them
Parallel circuit lights are built as so: ______light_______ |_____light_______| |_____battery_____| Series circuit lights are built like this: ___light___light___battery___ |________________________| In a parallel circuit, lights don't get dimmer when you add more, and if one breaks, the others still work. In a series circuit, when you add more, the lights get dimmer, and when one breaks, they all break. It is possible to have a combination of both in one circuit though.