Want this question answered?
The other components are still connected to the circuit
parallel circuit: Providing that the breakage does not result in a short circuit the other bulbs will still light. series circuit: If the breakage results in a short circuit through the bulb the other bulbs will light more brightly. If the breakage results in a breakage of the connection through the bulb then the other bulbs will not light.
If the bulb lights up then electricity is passing through the bulb. If the bulb doesn't light up then electricity is not passing through.
EASY.The removed light bulb does not have any connection to the other light bulbs. While it's socket that was holding the lght bulb has power running through it to the other bulbs also.
The colors are not created by the bulb. Instead, some form of filter (film, slides, transparent writing surfaces, etc) is placed between the bulb and the screen (or whatever surface onto which the light is being projected). The filter blocks certain portions of light from passing through, and allows others. The result is that a lighted version of the filter's coloration pattern (picture, writing, etc) is visible on the screen or surface.
That bulb goes out. The other bulbs remain on.
You could shine white light through it, divide the light that comes out the other side into the full spectrum of colors, see which colors were absorbed by the bulb and are therefore missing from the spectrum, and consult a table to find out what element corresponds to that pattern of color bands.
The resistance is increased, the voltage across each bulb is decreased and the current through the circuit is reduced.
Yes but very slightly,because temperature coefficient of bulb element is very low.
In a parallel circuit, the other bulb still works when one fails.
It gets heated up and glows spreading the light
It has to do with certain chemicals in the bulb that are made into color when the bulb is turned on.
when a light bulb is switched on it will blown..............
Either the bulb will start glowing or the magnetic needle will show deflection
The other components are still connected to the circuit
The remaining bulb will be brighter than it was when both bulbs were working - due to the increased voltage.
The bulb will get brighter