Want this question answered?
Voltage doesn't 'pass through' anything! Voltage is another word for 'potential difference', and is measured between two points in a circuit. For a transformer to work, it's necessary to apply an a.c. voltage across the transformer's primary terminals.
There is no physical connection between the primary and secondary of a transformer. A transformer is essentially 2 laminated coils of wire interwoven with each other. The magnetic field created in the primary coil is induced into the secondary coil creating voltage on the secondary side.
Presumably, you are asking what is the rated secondary current for a 45 kV.A (not 'kva') transformer? The answer depends on its rated secondary voltage. To obtain the rated secondary current, you divide the (apparent) power rating by its secondary rated voltage.
The product of the secondary rated current and the secondary rated voltage will give you the rated V.A of the transformer.
the difference between a step up transformer and a step down transformer is that, in a tsep up transformer, the voltage secondary is greater than the primary side but in a step down transformer, the voltage secondary is lesser than the primary side
The secondary (output) voltage is determined by the primary voltage and the turns ratio of the transformer. The secondary current is determined by the secondary voltage and the load resistance.
Compare a transformer to a balancing act. Both side need to remain equal.The primary side of the transformer is the supply side and the load is connected to the secondary side of the transformer.The load governs the current of the secondary side of the transformer and the voltage of the secondary side must match the voltage that the load required to operate.The ratio of the transformer will determine what the voltage of the secondary side is as compared to the voltage that has to be applied to the primary.The current of a step up transformer will be higher on the primary side that that of the secondary.Apply voltage and current to this concept and you will see that the transformer will remain balanced.The size of the transformer is always calculated from the secondary side of the transformer and the value is written in VA or KVA where V = voltage and A = amperage. Power factor is also taken into consideration when calculating the size of the transformer to be used.
Secondary voltage.
Assuming that the voltage rating of the lamp matches the rated secondary voltage of the transformer, the lamp will operate at its rated power.
Voltage doesn't 'pass through' anything! Voltage is another word for 'potential difference', and is measured between two points in a circuit. For a transformer to work, it's necessary to apply an a.c. voltage across the transformer's primary terminals.
Secondary voltage / primary voltage
no, infinite voltage can't be given to the primary of the transformer....if the secondary is connected to the load, then over voltage will damage the load, if secondary is open circuited, then the infinite voltage can breakdown the transformer internal insulation,
Transformer step-up/step-down voltage is turns-ratio, so if a transformer has 20 primary windings and 100 secondary windings (a turns-ratio of 1 to 5) and the secondary voltage is 25, then is the primary voltage is 5.
This is the transformed voltage, but it might also be identified as the secondary voltage as it is taken from the secondary winding.
The terms, 'primary' and 'secondary', describe how a transformer is connected and his nothing to do with which is the lower- and higher-voltage winding.The primary winding is the winding connected to the supply, while the secondary winding is the winding connected to the load. So, for astep-up transformer, the secondary winding is the higher voltage winding, whereas for a step-down transformer, the secondary winding is the lower voltage winding.For a loaded transformer, i.e. a transformer whose secondary is supplying a load, the higher-voltage winding carries the smaller current, while the lower-voltage winding carries the higher current.
The function of an isolation transformer is to electrically-isolate the secondary circuit from the primary circuit, without changing the voltage levels. So, its secondary voltage will be the same as the primary voltage.
Voltage on primary/Primary turns = Voltage on secondary/Secondary turns