The speed will increase possibly to the point that it throws out the coils from the armature & self destructs.
it will not run
AC series motor uses the electric current to run the motor. Whereas DC motor uses the battery power to run it.AnswerAn a.c. series motor is termed a 'universal motor', because it will run on either a.c. or d.c. A.C. series motors are constructed in essentially the same way.
It is a method of starting a three phase motor at a lower than operating voltage. The motor is operated at that voltage for a short specific time and then the controls switch to the motors full run operating voltage.
A shunt dc motor has quite different characteristics from a series motor. Wired in series, the same current passes through the armature and the field winding and it is most unlikely that a shunt motor would have a field winding that is suitable for this. Therefore a shunt motor cannot be wired as a series motor in general because its field winding is designed for only a small current.
dc series motor is used for traction...
it will not run
A machine with 2 wheels and a motor operating a rotary plough (basically a series of bent 'claws' fitted to axle driven by motor)
The motor needs to be replaced. There is a "switch" in the motor that "parks" the wipers. This happens when current is removed from the motor. Your "switch" in the motor is not allowing this to happen. Replace the motor.
I would not worry to much about this noise when the motor is cold; engines have clearanaces that come together at operating temperature. If this noise happens when the motor is at operating temperature then you might have a problem.
In D.C Shunt motor, the field winding is connected parallel with the armature winding.. If you remove the supply to armature winding, the motor will stop after some time.
when the load is removed the field is weakened then the speed is limited only by mechanical restraints ... (bearings, vibration, power available)
what are the advanced applications of dc series motor
series
Depending on the year, the wiper motor could be under the cowling or on the firewall. The firewall motor simply unbolts and is removed after the wires and linkage are removed. The cowling motor has to have the cowling removed first, then the wires and linkage are disconnected and the motor unbolted for removal.
It is a group of motor torpedo boats operating together.
I have a question for you before i can answer yours? is this an off highway motor or on highway motor please respond soon.
the method can not be used in the case of a d.c series motor