it will not run
230 Volt
Any two legs of a three phase system are classed as single phase. So yes a single phase motor will operate when connected. Be sure to use the proper motor protection devices to control the motor.
Your electrician is correct on this. However, the pump is designed for 230V and will use less electricity, thus saving money if wired for 230V. Yeah, if you have to rewire for 230 V then it would be more expensive until your savings had consumed or offset the expense.
As an electrician I can give you a vague answer with the information given. You need more specifics to do the calculations for the load amps and the supply voltage.The particular motor I looked at is a .6hp fan motor -4.0 Amps @ 230V(2650 x Full load amps ) divided by supply Voltage = MFDExample 2650 x 4amps = 10600 divided by 230volts = 46 MFDBut this is a general statement. The proper cap should be determined by researching the particular model you have.
The voltage rating of a fuse (in this case 125V or 230V) defines the maximum circuit voltage that the fuse is safe to be used on. A fuse with a voltage rating of 125V should not be used in a circuit with a voltage greater than 125V. If a 125V fuse were installed in a 230V circuit and an overload current occurred, the fuse could explode.
He dies.
It is not advisable because the motor would run 20% faster which might produce damaging overpressure in the thermal circuit.
230V/1Ph/50Hz 1HP (0.75 kW)Motor Capacitor start induction motor ( single phase)
You get a violent explosion as the diode vaporizes.
Typically single phase motors go up to 10hp. Wouldn't be very efficient at about 100 amps. A 20hp 3 phase motor at 230v pulls 52 amps. The 10hp single phase 230v pulls 50 amps.
For a 230V motor running 90ft away, it is recommended to use at least 12-gauge wire to minimize voltage drop and ensure efficient operation. However, it is always best to consult the motor's specifications and a qualified electrician to determine the most appropriate wire gauge for your specific setup.
AO SMITH UST1102 1.0 HP, 3450 RPM, Single Phase, 115/230v
i can fit da 180v dc motor . i wil put 1 inverter n selfrunning12v genrater to charge da inverter batery continosly.
No! Normally not, the recistance in the windings is to hig on 60Hz and the pump motor has not power enough to work propelly. This happened to myself when I connected my Whirpool AWE 7519 to 230V 60Hz. Europian model for 50Hz.
No bell wire is not meant to be 230V.
For a 1.5 hp 230v 3 phase motor, you can calculate the amperage using the formula: Amps = (HP x 746) / (Volts x Efficiency x Power Factor x √3). Assuming an efficiency of 0.85 and a power factor of 0.8, the amperage draw would be approximately 4.3 Amps.
no, the transformer is much more efficient <><><> HOWEVER- a transformer only changes the voltage of AC current- it does not change it to DC. You will still need diodes or rectifiers. You can also use a motor/generator- a 230v AC motor turns a 12 v DC generator.