Just the updated will not be fully installed therefore it will act the same as before the update started.
Hope this helps
GM vehicles do not have a fuel pump inertia switch.
Switch "off" the power
With the switch in the on position the receptacle is energized. With the switch in the off position the receptacle is de-energized.
When an electrical switch is in the off position, the circuit is interrupted. When the switch is on, the circuit is open and complete.
In the control handle. If you take off the switch cover you will see the wires that lead into it. Usually it will need to be soldoered to replace it.
Nothing you will just have to start all over on the update no damage will be done.
To set the emergency flashers on a Harley Ultra Glide, locate the hazard switch, which is usually found on the left handlebar control. Press the switch to activate the emergency flashers, and the turn signals will begin to blink simultaneously. To turn them off, simply press the switch again. Always ensure you’re parked safely before using them.
"Switch it off" is what we say in America.
As soon as you turn on the ignition, make sure that the radio is off. Turn the ignition switch back off until the display goes off and turn it back on, then just push the hrs or min button to set the time.
If the fuel pump inertia switch has " tripped " so the button on top of the switch has popped up , by pushing the button down the switch should reset and restore the electric flow to the electric fuel pump
Original Furbies do not have an On/Off switch. Emototronic Furbies have an On/Off switch on the bottom in between their feet.
Student Switch Off's motto is 'SWITCH OFF - SAVE ENERGY - WIN PRIZES'.