Check the application guide book at the parts store.
Look to the back of the headlight assembly. There will be a round sleeve where the wiring goes into the headlight. Twist this counterclockwise to turn the head light bulb assembly. Pull back on the assembly to remove it from the headlight casing. Replace with new headlight bulb.
To disconnect the wiring connector from the headlight bulb socket on a 2000 Chrysler Voyage, remove the wiring that goes into headlight plastic lock ring. Snap it loose and pull out the bulb socket.
It goes in with the V part towards the bulb, the V keeps the bulb in place.
Yes unless the bulb was broken in an accident. Bulbs have a finite life span, usually measured in hours. When one goes the other is not far behind. Replace them both.
check the bulb in the headlight that is not working if it is fine test your wires to make sure it is not shorted out some wear
3
I just changed the headlights on my 1999 Sunfire. There is a splash guard that goes over the very front of the inside of the car. Holding the guard down are some plugs (they're like wall anchors for hanging pictures in that they expand when they go into the hole to keep everything secure). Just stick a screwdriver under them and pop them out. Pull up the splash guard. You should see two large bolts right above where the headlight is. Remove those bolts, and the headlight assembly should come out. Once you get that part out, all you need to do is pull the old bulb out, carefully put the new one in, and reassemble. I hope my experience was similar enough to help.
The wiring harness goes into a boot on the back of the headlight assembly. Twist the boot until the three-pronged tabs are aligned with the slots and pull the boot/bulb out of the headlight assembly. Pull the bulb out of the boot. Do not handle the new bulb with your fingers. Assembly is the reverse of the removal.
First check bulb, if good, must be in the switch. Bad contact. Open it up and clean the contacts. The headlight circuit on these bikes goes through the starter switch as well. If part of that switch goes bad the headlight will not work.
First remove the headlight cover that goes around the bulb. There are two phillips head screws on the bottom of the cover that allow for this. Next remove the four screws (use a 10 mm socket for this) holding the headlight in place. Pull the headlight assembly forward. Remove the plug at the base of the bulb. There is a clip holding the bulb in place. Press down on the end of the clip and it should pop up. The bulb should come out very easily after this. Install the new bulb being careful not to touch the glass with your bare fingers. Reassemble the unit in the opposite order it was disassembled.
Lift the hood, and in the front you can see where the bulb goes into the casing. There is a plastic washer with tabs that you turn 1/4 with your hand, it is not tight, and pull the housing with the bulb out. Then, press the outer housing where the long tab is and you can pull the bulb housing out. The just pop in the new one and turn back the washer and insert into the headlight casing from behind.
Get under the car reach behind the bumper reach towards the blinker then find the wire that goes to it. Then twist the end left and pull out the light bulb in and and replace. For the headlight blinker you have to unscrew the headlight with either a 10 or 13mm socket...pull it out...then twist the end that goes into the blinker left...replace bulb....put things back together....done.