answersLogoWhite

0

the chip escape route

User Avatar

Wiki User

14y ago

What else can I help you with?

Related Questions

What are the functions of the flutes in a twist drill?

to auger the chips out of the hole.


A fix for water getting into headlight assembly 2000 Lincoln LS?

drill a small hole in the back or bottom of the head light assembly to allow the moisture to escape.


What is the purpose of the groove on a twist drill?

To auger (carry) the chips out of the hole.


Does the spade drill allow for easier drilling?

Spade drills do allow for easier drilling, especially if the goal is to drill out a large hole. They are intended to be quick, powerful, and to last longer than their spiral-drill counterparts.


Where can one find a brain drill?

A brain drill is found in an operating room. The drill does not actually drill into the brain, it creates an opening in the skull to allow the surgeon to operate on the brain.


What factors that may indicate that the drill bit should be reconditioned?

It takes a longer time to drill a hole than it should. You see burning or smoking instead of chips.


How to smoke on a gas grill with chips?

To smoke on a gas grill with chips, first soak the wood chips in water for at least 30 minutes. Then, wrap the soaked chips in aluminum foil and poke holes in the foil to allow smoke to escape. Preheat the grill on high, then turn off one side of the burners. Place the foil packet of wood chips on the lit side of the grill and the food on the unlit side. Close the lid and adjust the temperature as needed to maintain a low heat for smoking.


What is the best type of drill bit to use for making holes in wood?

For making holes in wood, the best type of drill bit to use is a twist drill bit. These bits have a sharp point and spiral grooves that help to remove wood chips as you drill, resulting in clean and precise holes.


Does the atmosphere allow heat to escape quickly in order to cool the planet?

No the atmosphere does not allow heat to escape quickly to cool the planet


Wood chips in ferro silicon furnace?

they provide a void for gases in the metal to escape.


What is the difference between a wood drill bit and a metal drill bit?

A wood drill bit is designed specifically for drilling into wood, with a sharp point and wider flutes to remove wood chips efficiently. A metal drill bit, on the other hand, is made of a harder material and has a more aggressive cutting edge to drill through metal surfaces effectively.


How can I effectively drill deep holes in wood?

To effectively drill deep holes in wood, use a sharp drill bit that is appropriate for wood. Start by marking the desired depth on the bit with tape. Secure the wood firmly in place and drill slowly, applying consistent pressure. Clear away wood chips regularly to prevent overheating. Keep the drill straight to avoid splintering.