answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: What is A round handle that you turn to let your self in?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Continue Learning about Engineering

How to test plumbing trap?

Turn on the the water to the fixture. And let in run.


Increase hot water pressure?

You cannot increase hot water pressure only. If this is low, your tank may need cleaning - You first turn OFF the power to tank, then attach a hose pipe to the bottom fitting, lead it outside or to any drain, turn on the valve by it, turn OFF your inlet valve and open the relief valve so air can enter the H/W tank.Let the whole tank empty -takes about 30 -40 minutes. Next, when empty turn ON the inlet valve and let cold water run through the tank and out the hose, now you will see the sludge coming out. Let this run 5-7 minutes or until water is coming through clean. Now you are done . Let it fill, then turn on power.


Do you need to replace hot water heater if the bottom of the heater is rusted?

If not leaking and water heater is working fine, no.Improved answer. -Drain and clean out your tank, and change the anode.Drain a H/W tankYou first turn OFF the power to tank, then attach a hose pipe to the bottom fitting, lead it outside or to any drain, turn on the valve by it, turn OFF your inlet valve and open the relief valve so air can enter the H/W tank.Let the whole tank empty -takes about 30 -40 minutes. Next, when empty turn ON the inlet valve and let cold water run through the tank and out the hose, now you will see the sludge coming out. Let this run 5-7 minutes or until water is coming through clean. Now you are done . Let it fill, then turn on power.


How can you tell it's an interference engine or If it's a non-interference engine?

If you give the yr/make/model/engine, could let you know... But if you want to find out your self. You need to turn piston 1 to TDC and depending on the engine, undo the valve spring keeper and measure how far the valve drops until in hits the piston. Subtract .050 of an inch and if it is less than the max valve lift you have an interference engine.


Why does an engine have valves?

To let the fuel and air into the cylinder and to let the exhaust out. Inside a motor there is a space (cylinder) where fuel and air is compressed by a piston then ignighted by a sparkplug. A valve is a little round disk with a stem coming out of its middle. The valve moves into that space creating an outlet around it past the stem. Every cylinder will have at least two valves.. 1 for fuel & air and 1 for exhaust. Hope that was helpful I tried to keep it simple as possible. To let the fuel and air into the cylinder and to let the exhaust out. Inside a motor there is a space (cylinder) where fuel and air is compressed by a piston then ignighted by a sparkplug. A valve is a little round disk with a stem coming out of its middle. The valve moves into that space creating an outlet around it past the stem. Every cylinder will have at least two valves.. 1 for fuel & air and 1 for exhaust. Hope that was helpful I tried to keep it simple as possible.

Related questions

How do transplant a cactus?

Carefully. If you need to handle it out of its pot fold a sheet of newspaper up and use it wrapped round the plant to let you handle it.


What is a good sentence for the word dangerous?

You should never let a toddler handle a knife by him/her self because it is very dangerous.


How do you reverse a capias warrant in nh?

Contact the court that issued it or turn yourself in. If you are represented by counsel, let them handle it.


What are some of the spirituals sung in Selma Lord Selma?

Ain't going to let nobody turn me round.


BMW 318i and it let you unlock it put key in and got ignition lights butdoes not turn the key just spins round and round what could cause this please?

Broken switch, replace it.


When was Let's Polka 'Round created?

Let's Polka 'Round was created on 2003-08-26.


What was the most important song of the civil right movement?

Oh, there were tons! But one of the most famous is "Ain't Gonna Let Nobody Turn Me Round."


When was Let's Go Round Again created?

Let's Go Round Again was created in 1997-11.


Should kassie let mom handle this situation?

yes she should. if she doesnt let her handle it something bad is gonna happen.


What were the terms of the understanding between orpheus and Hades?

Hades promised to let Eurydice return, if on the trip Orpheus would not turn round before reaching his own home.


What is green round light on 2000 Jeep grand?

If it is the light in the gauge console, it is to let you know the headlights are on automatically. Like when the windshield wipers are on, or that its dark enough to have them turn on.


Who wrote Ain't going to Let Nobody Turn Me Round?

sweet honey rock is who i was told to have had this song made. i believe it is them who made it though because i heard them sing it.