answersLogoWhite

0

S means "Sport"in automatic transmission cars, so that engine can be run in higher revs and more power can be used.

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

What is s gear in Toyota belta?

The Belta is a small car made by Toyota it was first produced in 2005. It has a sports mode, you can choose by putting your car into the S gear.


What is the gear ratio for a 1983 Toyota 4x4?

4.11 I believe. Good enough to roll 31's on stock 22r.


When was Toyota Type S Engine created?

Toyota Type S Engine was created in 1947.


What would cause a growl while in gear?

it,s the bearings or a bad gear.


What is triptronic gear transmission?

it`s amanumatic type of gear which can be operated manualy or automatic


99 v6 mustang rear end gear ratio?

It has a 3.27 gear on it, if upgrading i would suggest 3.73's or 4.10's.


What is the most reliable mini truck?

The most reliable pickup truck would be a mid-80's Toyota Hilux. They are good for over 200,000 miles or 20 years of service and practically indestructible as proven by Top Gear.


Who makes the gear: a scientist, an engineer, or a technologist?

An Engineer: The engineer that designs the gearbox. The sizes of the bull gear and pinion gear(s), as well as any idler gear(s) are dependent upon the sizes of the drive and driven shafts and the torque that will be applied to each, as well as the ratio of gear reduction, and speed of rotation.


What is the funcion of a ring gear?

It is to transfer the power between the driveshaft and the wheels. The drive shaft drives the pinion, the pinion drives the ring gear, the ring gear drives the axle(s) and the axle(s) drives the wheels.


How many sensors in a Toyota rav4?

Toyota RAV4's have two (2) O2 sensors.


What country are toyota' s made in?

Japan


Who decides how big a gear should be a scientist a engineer or a technologist?

The engineer that designs the gearbox. The sizes of the bull gear and pinion gear(s), as well as any idler gear(s) are dependent upon the sizes of the drive and driven shafts and the torque that will be applied to each, as well as the ratio of gear reduction, and speed of rotation.