The header of an IP packet does not include fields required for reliable data delivery. There are no acknowledgments of packet delivery. There is no error control for data.
Simplified header format. IPv6 has a fixed length header, which does not include most of the options an IPv4 header can include. Even though the IPv6 header contains two 128 bit addresses (source and destination IP address) the whole header has a fixed length of 40 bytes only. This allows for faster processing. Options are dealt with in extension headers, which are only inserted after the IPv6 header if needed. So for instance if a packet needs to be fragmented, the fragmentation header is inserted after the IPv6 header. The basic set of extension headers is defined in RFC 2460.
Its used to detect an error if the packet may be mis-routed. I'm not 100% sure.
aqs WD
There are two address fields. Source is the IP address the packet came from and destination is the IP address the packet is meant to be delivered to.
ip packet header
ip packet header
Internet Protocol, or IP, puts a header on every packet that it sounds out. This header is the overhead. All protocols, such as TCP or UDP, will put a header on the packet. The IP header contains information such as source IP address and destination IP address and is used by routers to figure out where to send the packet. ex. you send your friend a 1kb file, but it takes up 1.5kb of bandwidth due to overhead
header, packet(data), and trailer
See time-to-live (TTL) packet
An IP packet can contain data about the format of the internet header and the abstract parameters such as the header checksum. The IP packets also provide an internet time stamp.
packet-filtering
the answer is a Header,the a Payload, then last is the Trailer