in a radial flow turbine the steam enters the turbine in the direction of its radius and leaves it in the direction of the axis of the shaft. in a axial flow turbine the steam enters the turbine in the direction of the axis of the shaft and leaves the turbine in the same direction.
The Kaplan turbine is a newer, more revolutionary version of the Francis turbine, which came before it. The draft tube is used so that the turbine does not need to be where the water flow is lowest.
by controlling main steam flow
The turbine flow meter translates the mechanical action of the turbine rotating in the liquid flow around an axis into a user-readable rate of flow. The turbine tends to have all the flow traveling around it. The turbine wheel is set in the path of a fluid stream. The flowing fluid impinges on the turbine blades, imparting a force to the blade surface and setting the rotor in motion. When a steady rotation speed has been reached, the speed is proportional to fluid velocity. Turbine flow meters are used for the measurement of natural gas and liquid flow
A wind turbine is a form of electric generation. On top of a tall pole there is a turbine (fan thing) and the wind spins it around. The turbine is connected to a motor which generates an electromagnetic flow from the motion.
When flow of water on turbine is tangential, flow is tangential flow
in a radial flow turbine the steam enters the turbine in the direction of its radius and leaves it in the direction of the axis of the shaft. in a axial flow turbine the steam enters the turbine in the direction of the axis of the shaft and leaves the turbine in the same direction.
Machinability for airframes, helicopter,landing gear applications, turbine engine applications....
the peripheral velocity of the turbine is the around velocity. the increase in the velocity of the peripheral will decrease the velocity of the flow towards the turbine
Machinability for airframes, helicopter,landing gear applications, turbine engine applications....
The inward flow reaction turbine having radial discharge at outlet is called Francis turbine
The three sensors are [input sensors] that are wired to the Transmission Controller to give speed information to the Controller for proper shift points,[up-shifts-down shifts Input Turbine Speed.... Output Turbine Speed.. Vehicle Speed sensor...
The length of a blade depends on the style (impulse or reaction), the overall size of the turbine, whether it is an axial flow or radial flow turbine, and where the blade is located within turbine of an axial flow turbine. One thing that is constant: the length of the blade increases from the steam or gas inlet to the discharge of the unit. The profile will gradually increase in diameter from inlet to discharge.
kg/s
No these are two different sensors. The thrust bearing temperature trip device measures either the metal temperature of the bearing, or the oil temperature exiting the bearing, or both. If this temperature exceeds recommended temperatures by 10 to 15% the turbine will trip to avoid damaging the bearings or shaft. The rotor position sensor is a proximity cell that monitors the axial position of the turbine rotor, often there is four such sensors mounted at the end of the rotor, if the distance between the sensors and the rotors exceeds a specific distance ( often 15-30 mils) the sensors indicate a failure, if two or three sensors indicate failure the turbine will trip.
Eric Udd has written: 'Fiber optic sensors and applications VI' -- subject(s): Optical fiber detectors, Congresses, Fiber optics, Multiplexing 'Development and evaluation of fiber optic sensors' -- subject(s): Measurement, Optical fiber detectors, Traffic flow 'Applications of the Sagnac Interferometer and Ring Resonator' 'Fiber optic sensors' -- subject(s): Optical fiber detectors, Fiber optics
electricity created by the flow of water turning a turbine