Want this question answered?
the catalyst is used inside the reactor to activate the reaction of the ethylene and oxygen in order to produce ethylene oxide EO. those catalyst are small Wight balls fit inside the reactor tubes and by passing combined gases (oxygen, ethylene, nitrogen, and some other gases) they will react in a maintained temperature and pressure then form the EO. There are two types of catalyst: high selectivity catalyst low selectivity catalyst i wish that i answered the question & glad to answer any further question.
No; a catalyst is used to speed up a reaction, and catalysts should remain in their initial states at the end of a reaction. Catalysts include: Fe Ni H2SO4 H3PO4 ** a system may act as a catalyst for altering water by definition the G7 water catalyst is such.
Yes, a catalyst can be re-used, because It is NOT actually used in a chemical reaction. A catalyst will increase the rate of reaction by attracting reactants, but the catalyst is not a reactant. However, the reuse cannot be done indefinitely then, depending on the severity of the reaction conditions, it can be occur a small, but accumulative deactivation of the catalys.
a) oxygen does not burn b) oxygen combines with the fuel - it is NOT a catalyst. c) a fire does acellerate when oxygen is added.
A catalyst is anything which causes a chemical or physical reaction. As such almost anything other than the most inate chemicals could act as a catalyst.
it is used to prepare oxygen
On the 4.0 L OHV engine - 2 oxygen sensors - and one sensor used as a catalyst monitor for catalytic converter efficiency mounted downstream of the converter On the 4.0 SOHC engine - 2 oxygen sensors and 2 catalyst monitors
the catalyst is used inside the reactor to activate the reaction of the ethylene and oxygen in order to produce ethylene oxide EO. those catalyst are small Wight balls fit inside the reactor tubes and by passing combined gases (oxygen, ethylene, nitrogen, and some other gases) they will react in a maintained temperature and pressure then form the EO. There are two types of catalyst: high selectivity catalyst low selectivity catalyst i wish that i answered the question & glad to answer any further question.
I believe there are 2 oxygen sensors that are used for air / fuel ratio and 2 oxygen sensors that are downstream from the catalytic converters and are called catalyst monitors
Chlorophyll is the catalyst that is used in the process of photosynthesis.
the widely used catalyst is V2O5 .
No; a catalyst is used to speed up a reaction, and catalysts should remain in their initial states at the end of a reaction. Catalysts include: Fe Ni H2SO4 H3PO4 ** a system may act as a catalyst for altering water by definition the G7 water catalyst is such.
Yes, a catalyst can be re-used, because It is NOT actually used in a chemical reaction. A catalyst will increase the rate of reaction by attracting reactants, but the catalyst is not a reactant. However, the reuse cannot be done indefinitely then, depending on the severity of the reaction conditions, it can be occur a small, but accumulative deactivation of the catalys.
Yes. it is a part of recycling of catalyst.
In the production of ammonia, Iron is used as a catalyst
a) oxygen does not burn b) oxygen combines with the fuel - it is NOT a catalyst. c) a fire does acellerate when oxygen is added.
A catalyst is anything which causes a chemical or physical reaction. As such almost anything other than the most inate chemicals could act as a catalyst.