0
It is a valve in the brake lines going to the rear of the vehicle. It adjust the amount of fluid flow to the rear brakes depending on the height of the rear suspension. The lower the suspension, the more weight in the vehicle, the more rear braking power is needed.
What else can I help you with?
Where is the proportioning valve located on a 1984 corvette?
AnswerThe proportioning valve and warning switch is integrated into the master cylinder assembly.I think the proportioning valve is located on the frame rail under the master cylinder?Thats where it is on my 1980.The proportioning valve is not on the frame rail on an 84. It is inside the master cylinder.
Is a proportioning valve is part of an automotive electrical system?
No, the proportioning valve is used in the brake system to apply different forces of pressure to the front and rear brakes.
A proportioning valve is part of an automotive electrical system.?
No, the proportioning valve is used in the brake system to apply different forces of pressure to the front and rear brakes.
Do you have to replace the proportioning valve when replacing the master cylinder?
No, not unless there is a problem with the valve which is rare.
Does the Kia sephia have proportioning valves?
Yes the kia sephia has 2 brake proportioning valve located on the fire wall
Is a proportioning valve and a brake force regulator the same thing?
The proportioning valve adjusts the amount of fluid pressure between the front brakes and rear brakes, I would say the answer is yes.
Where is the proportioning valve on 98 Dodge Intrepid?
There are four proportioning valves. They are located by all four tires within the brake line. It is a small cylinder shaped valve about two inches long.
Where is the brake proportioning valve on a 2000 dodge stratus?
The proportioning valve is on the drivers side in the rear, just follow the brake line from the wheel cylinder, rubber line, you will see it at the end of this line.
What is the part that your brake lines connect to under the hood it hold all four line?
It depends on the year of the vehicle, if it has a dual reservoir it would be a proportioning valve. If it has a single bowl reservoir it would be just a junction block.
After replacing hard brake line is there a proportioning valve to reset on your 1998 Chevy silverado?
There is a proportioning valve and once the repair is done and you have bled all the air out of the system the valve should reset itself unless it is stuck. If it is stuck you may have to replace the valve assembly if you can't free it up.
What does a proportioning valve do?
Balances braking force between front and rear wheels.
What device is employed to compensate for the different braking forces required?
Proportioning valve
