The faraday is the unit used to denote a quantity of electrical charge. It is equal to the charge of one mole of electrons, and is also equal to 96,485.3365 coulombs. It is not to be mistaken with Faraday's constant, a related number denoting electrical charge.
The Farad is a measure of how much electric charge is accumulated on the capacitor. Named after Michael Faraday
Unit of capacitance.
a capacitor
Capacitors
capacitance
By definition an electrical circuit is a route or path that starts and finishes at the same place. So there is no part of an electrical circuit that is not necessary, because if there were it would not be an electrical circuit.An electrical circuit needs a power source. Conductors to transmit the voltage from the power source to the load. The final component of the electrical circuit is the load that you want to energize.If you remove any of the components there will be an open circuit and the load will be impossible to operate.
No, it would be measured in cubic feet.
Length is measured in meters.Length is measured in meters.Length is measured in meters.Length is measured in meters.
Anything physical can be measured in cm.
The width of a highway would be best measured in meters. The length would be measured in kilometers.
The rate at which work IS being done - or at which it would be done if you switched on an electrical appliance or some other piece of electrical equipment - is called 'power' and it is measured in watts.
The electrical conductivity is measured.
They are each measured in volts (V).
RESISTOR STABILITY Vs TEMPERATUREThis identifies the temperature coefficient of the resistor range. Do not confuse this with the resistor value, it relates to the composition of the resistor, be it carbon film, metal film, windwound or whatever. The term "ppm/°C" is not specific to resistors, it applies to almost every single electronic component ever produced, and is a measure of how much that component's stability will drift in response to a change in temperature. This is usually measured in terms of 'parts per million per degrees centigrade' - ppm/°C. The meaning of "parts" is the units of which that component is measured, here it is Ohms. If we were referring to capacitors the units would be farads, microfarads or picofarads etc. Oscillator frequency stability would be in terms of Hertz
1 kpf (kilo pico farads) is equal to 1 nf (nano farads), so there would be no affect.
It would depend on the institution granting the degree. Electrical would seem to be a broader term that would encompass a wider range of disciplines. Electronic could refer to disciplines like circuit design or component design and manufacturing.
If you have a measured continuous load of say 80 Amps, you would want to have a panel rated at 100 A. For continuous load you want to be at 80% of rated capacity.
Any electrical appliance would be the object eg. a motor, a light, a heater etc
Electrical impulses; inspiration; brainstorm.Brain waves are electrical impulses given off by brain tissue which can be measured by an electroencephalogram.Brain waves can also mean an inspiration, sudden idea or brainstorm.
No. It would be measured in Liters.
It would be best measured in centimeters
No. It would be measured in pages