0
A barrel nut connector is a cylindrical push-and-twist connector for connecting thin coaxial cable.
Wiki User
∙ 8y ago
Add your answer:
Earn +20 pts
What is a barrel nut?
A barrel nut is an internally threaded screw with a slotted head.
What special tool is used to remove nut on the barrel of a Remington Woods Master model 742?
Barrel nut wrench available through Brownells.
Where you get tools to work on 357 Dan Wesson pistol?
common Allen wrenches but to remove the barrel or barrel nut look for dan Wesson parts i recently bought nut removal tool as a kit,
What is the big nut looking thing on the fuel lines next to the fuel filter?
the connector.
What are the three parts to a nut?
i have no idea i am asking you for the anser
Where can you purchase a barrel nut for a feather industries AT22?
there is on currently on gunbroker for 16.00
What is BNC probe?
A:BNC bayonet neil concelman is not a probe nut rather specify the type of connector that it can be plug in. BNC is a well known connector widely used
Dan Wesson 357 magmum ctg with a 2 barrel how can you tell if it will enterchange to different size barrels?
Dan Wessons have a nut inside the front of the barrel that has to be removed to remove the barrel shroud and barrel. Keep in mind that Dan Wesson barrels are two pieces, the barrel itself, which is just a rifled tube that is threaded on each end, and the outer shroud. Once the barrel nut is removed the shroud just slides off and the barrel can be unscrewed from the receiver. When you put another length barrel on the gun you just screw in the new longer or shorter barrel tube, slip the shroud in place and tighten the barrel nut to hold everything in place. There is a special wrench that is designed to remove and add the barrel nut. You also need to be careful and measure the gap between the cylinder and the force cone of the barrel. DW makes a gauge to adjust this properly. If the distance is too small the cylinder can bind as it turns. A too-large gap effects accuracy and can be a safety problem.
Will a MarkV Sten barrel fit a MarkII Sten?
Yes, the barrell, shroud and nut assembly are the same.
What is the difference between a barrel connector and a repeater in terms of data transmission over bus topology network?
jb
How do you put in a new ignition switch on a 1973 Honda 125?
If you have a replacement ignition switch for the same bike. You take the retaining nut off the end of the key barrel and slide it out and you unplug it, then you plug in the new one and put the new key barrel back in and tighten the nut.
How do you disconnect spark plug wires on a 2001 Dodge Dakota 4.7 liter motor?
It does not have spark plug wires. It has a coil on each plug. You unplug the electrical connector, remove the hold down nut, and lift the coil off.It does not have spark plug wires. It has a coil on each plug. You unplug the electrical connector, remove the hold down nut, and lift the coil off.
